473798
104
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
Protect PV.500 Installation and Start-up
16 of 20 80000031353 BAL
Î Remove any cable debris, tools, bolts, etc. from the connection
panel.
Î Replace the partition plates in the floor of the cabinet.
Î Reattach the connection cover.
Connection of the control and signal lines
The control and signal lines for remote signalling are connected
using a 3 mm screwdriver.
Shielded control and signal lines may be advantageous in terms of
EMC.
Î For this purpose, connect the shield of the lines to the terminal
unit. Additionally, the shield can be connected to the PE con-
nection provided on the control unit pivot plate.
Î The protective earth conductor is laid in accordance with VDE
0100 T540.
i
The cable clamp rail is located 130 mm above the floor.
Observe the bending radius!
(With one bend: radius = 10 x diameter)
6 Start-up
Special AEG Power Solutions software and hardware tools must
be used for initial start-up. Only skilled personnel trained by AEG
Power Solutions are in a position to use these tools correctly and
to perform initial start-up.
Once the system has been fully installed, the following aspects
must be checked:
z Screw connections properly tightened
z Connection cables correct
z Tool removed
z Terminal space covers attached
Read the operating instructions prior to start-up.
104

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für AEG Protect PV 500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von AEG Protect PV 500

AEG Protect PV 500 Bedienungsanleitung - Deutsch - 136 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info