648281
13
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
If the cable gets damaged and has to be changed, do not do this
yourself – take the equipment to an authorised repair centre
because the work must be done by specialist personnel to avoid
any risk of damage.
Do not use this heater close to showers, baths, water basins or
swimming pools.
The product must be positioned in such a way that the power
supply socket can always be reached.
It must never be possible for people in the bath tub or shower to
reach the adjustment knobs.
This heater must be correctly installed in compliance with the
regulations in force in the country of installation.
The electrical connection to the power supply must also be fitted
with a two-pole switch with a minimum gap between the contacts
that allows complete disconnection according to excess voltage
III category conditions.
WARNING: Do not use this heater in small rooms when they are
occupied by persons not capable of leaving the room on their own,
unless constant supervision is provided.
WARNING: Operate this heater at a distance of 1m from textile,
curtains and/or any flammable materials.
Important warning
If you have purchased a new product or if you have left your product without function for a long period, when
switching it on you may smell an odour.
This is due to the deposit of dust or impurities on the surface of the heating element. The smell is not dangerous for
health and it will disappear in a few minutes
3. Safe positioning
Only use the equipment in a horizontal position.
If used as a portable unit, always respect the minimum distances from any inflammable object indicated in
figure 2.
For wall mounting respect the minimum distances from the ceiling, floor, and side walls shown in figure 3.
In bathrooms never install or use the equipment within zones 0 or 1 shown in figure 4.
The regulating knobs must never be accessible to people in a bath or shower.
The product must be free to take air in and expel it.
For portable use:
Assemble the pedestal by screwing the rod (figure 1/D) to the base (figure 1/C) with the 2 countersunk
screws supplied (fig 5).
Insert the pedestal rod in the relevant rectangular slot that can be seen in the lower grille on the product
(figure 6).
Fix the pedestal to the product using the 4 screws supplied at the points indicated in figure 7.
This product has double electrical insulation and does not require an earth connection.
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für AEG SHG150 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info