Bedienungsanleitung AEG SLH ST (Seite 11 von 32) (Deutsch, Englisch)

648285

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Installation - for contractors

2.3 General safety instructions

WARNING Injury

The appliance may be used by children aged 8 and

up and persons with reduced physical, sensory or

mental capabilities or a lack of experience provided

that they are supervised or they have been instruct-

ed on how to use the appliance safely and have un-

derstood the resulting risks. Children must never

play with the appliance. Children must never clean

the appliance or perform user maintenance unless

they are supervised.



commissioning, maintenance and repair of the appliance.

We guarantee trouble-free function and operational re-

liability only if the original accessories and spare parts

intended for the appliance are used.

3. Appliance description



way of keeping pipework free from frost, particularly out-

doors. It consists of 2 supply conductors routed in parallel,

that are separated from each other by a special semicon-

ductor matrix.

At low temperatures the electrical resistance of the rib-

bon heater drops, causing the output to increase. At high

temperatures the resistance rises and the output drops.

The ribbon heater can be trimmed individually. The end

of the ribbon heater can be appropriately resealed with

the terminators provided.

Note

The use of higher ranking control units is advisable

as these can save energy, keep process tempera-

tures constant and protect the ribbon heaters.

» If in doubt, consult our service department.

4. Installation

4.1 Protective measures

WARNING Electrocution

We strongly recommend the use of an RCD (30 mA).

» If you are using the ribbon heater on metal, make

sure you protect the ribbon heater against indi-

rect contact to DIN VDE 100, part 410 prior to

commissioning.

» Protect the ribbon heater against mechanical and

chemical damage.

4.2 Preparations

» 

the pipe is freely accessible.

» 



optimal heat distribution.

4.3 Installing the heating circuit

Material damage

Keep the ribbon heater away from any sharp edges



the ribbon heater and surrounding areas.

Note

There is no danger of overheating if ribbon heaters

overlap or touch.

» Remove sharp burrs or any other roughness from the

surface you will be heating.

» Clean and degrease the surface you will be heating.

Power supply

WARNING Electrocution

Carry out all electrical connection and installation

work in accordance with relevant regulations.

Material damage

Observe the type plate. 

match the mains voltage.

D0000032847

» To prevent condensate from the pipe entering the

standard socket, form a "drip loop" with the power

cable.

Positioning the thermostat

The thermostat measures the temperature of the pipe and

switches the ribbon heater on and off as required.

D0000032852

» 

pipe at the coldest end of the pipe. -

ing materials for this purpose, such as fabric tape,

aluminium adhesive tape or temperature-resistant

cable ties.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG SLH ST Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info