Bedienungsanleitung AEG WKL 1002 (Seite 6 von 24) (Deutsch, Englisch, Holländisch, Französisch)

464394

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

1. Operating instructions

1.1 Switching on the Unit

The unit may be switched on (setting I) or off (setting O) by using the switch (1) on the right hand side

panel.

1.2 Heater

Turning the temperature selector (2) to the left will turn on

the heater and select the required temperature. Once turned

on, the heater will warm the room uniformly and quickly.

Air enters the heater from below where it is heated and then

exits through the grid at the top of the heater. The room

temperature can be infinitely set between approx. 6 °C and

30 °C. The thermostat switches the heater off once the set

temperature has been reached and switches on and off

intermittently to maintain the required temperature.

If uniform temperature is required in two rooms, do not set

both heaters to the same setting. The same applies to two heaters installed in the same room.

In order to minimize energy usage when airing the room by opening the windows, it is advisable to switch

off the unit.

1.2.1 Anti-frost setting

Set the temperature selector (2) to á.

The thermostat will switch the heater on automatically if the room temperature drops below approx. +6 °C.

Ensure the correct heater is fitted to cope with the demands to be made upon it.

1.2.2 Limiting the temperature range

In order to lock the selector at a specific temperature, remove

the two pins (3) from the rear of the housing and insert either

side of the desired setting. The two pins may also be used to

limit a temperature range.

1.3 Safety notes

The appliance must not be operated:

– In areas which are subject to the risk of fire or explosion

due to chemicals, dust, gases or vapours;

– In the immediate vicinity of pipes or containers which

carry or contain combustible or potentially explosive

substances.

For this reason, the minimum clearance intervals must not be undercut.

In workshops or other areas in which the odour of waste gases, oil, petrol, etc. might occur, or in

which work is carried out involving solvents and chemicals, there is a risk of sustained odour burdens

being engendered, and possibly of dirt contamination occurring.

The air outlet must not be obstructed. For safety reasons the

upper and lower air grilles must never be covered with items

such as washing nor obstructed by items in too close

proximity (see figure 3). Objects should not be leant against

the unit nor placed between the unit and the wall. Never

leave combustible materials, such as wood, paper, textiles or

flammable items such as wax, petrol, aerosol cans etc. in the

vicinty of the warm air outlet.

As with all similar heaters, the flow of rising air may cause

discoloration of the wall.

Before using any materials which produce flammable gases or vapours, e. g. laying or sealing parquet

or PVC flooring, or when using spray polishes, spirits and similar materials, ensure the heater is

switched off.

1.4 Servicing

Do not use abrasive or aggressive cleansers to clean the heater.

Use a vacuum cleaner regularly to clean the upper and lower air grids.

For the User

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG WKL 1002 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info