Bedienungsanleitung AEG WSP 300 H (Seite 24 von 76) (Deutsch, Englisch, Holländisch, Französisch)

464372

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

For the User and the Fitter

1.4 Care and Maintenance

●

AEG heaters have been constructed so that they need only a minimum of maintenance.

●

The fans are equipped with self-lubricating bearings. We recommend that the heater be opened

from time to time by a qualified installer who can free the heater from any dust which may have

accumulated on the fan or in the air-outlet channels.

●

Cleaning and maintenance intervals are dependent on the conditions under which the heater

works. We recommend that the first check take place at the latest before the beginning of the

second heating period. Further maintenance intervals can then be individually set.

●

We recommend that the control and regulation elements of the heater also be checked regularly.

All safety, control and regulation elements should be checked by a qualified installer at the latest

10 years after initial installation. This can save unnecessary energy costs.

●

Do not use soft-scrub or other abrasive substances to clean the surfaces of the heater. Normal

household cleaners suffice entirely.

1.5 Important note

1.5.1 General

Please read this instruction carefully. It contains important information on safety, installation, use

and maintenance of the heater.

The manufacturer cannot be held responsible for problems occurring when the following

instructions are not adhered to. The appliance must only be used for the function intended.

This instruction leaflet must be:

●

handed to the heater user after installation. The user is also to be instructed on the way this

electric storage heater works.

●

read carefully, retained for further use, and handed over to a new owner/user.

●

given to any maintenance engineer before repair work is carried out.

1.5.2 Defects

If the heater does not function correctly, please check the following points:

●

Is the heater charge control set to no-charge?

●

Is the complete heating system switched off (via main switch)?

●

Are the circuit breakers in the distribution box loose or defect?

●

If the heater cabinet is warm, but the fan is not running:

Is the room thermostat working?

Are the fuses for the fans in the distributor box loose or defect?

1.6 Trouble Shooting Tips

AEG Storage heaters are equipped with a continuous running charge and discharge control and a

charge safety non-resetting limit switch. If the charge and discharge control does not switch off

the elements under normal charging conditions, the non-resetting safety limit switches off the

power supply to the elements. Problems in this category must only be repaired by a qualified

installer (see Chapter "Important Instructions", 2.2.1).

If the heater does not work correctly, the following checks should be undertaken:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG WSP 300 H Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info