587629
15
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
15
INSTALLATOR SET
Description Default value
Cond.low
Condensation regulation setting corresponding to the external
temperature T.C.low
17 bar
Diff.low
Condensation regulation differential setting corresponding to the
external temperature T.C.low
20 bar
Cond.hig
Condensation regulation setting corresponding to the external
temperature T.C.high
17 bar
Diff.hig
Condensation regulation differential setting corresponding to the
external temperature T.C.high
12 bar
Cond. PC
Corresponding condensation regulation setting in the heat pump
45 bar
Diff. PC
Condensation regulation differential corresponding to the heat pump
5 bar
T.C.low
Low outside temperature limit for the selection of the setting and
selection differential
-5 °C
T.C.high
High outside temperature limit for the selection of the setting and
selection differential
40°C
Volt Min
Minimum DCP output voltage when cold
1V
DcpR Off
High pressure value below which DCP output is 0 volts during low
temperature pre-ventilation.
22 bar
DcpR On
High pressure value above which DCP output is 10 volts during
low temperature pre-ventilation
23 bar
S. R Heating
Thermostat setting to manage the water inlet recovery.
50°C
D.Tot.R
Setting to determine the distance between one step and the
following one, in the recovery operation setting.
5°C
T. OutS.
Temperature (read by the probe on the fluid) above which the
DEFROSTING action can END
20°C
Number of
resistors
Number of supplementary heaters (number of steps).
0
Set Res
External air setting under which electrical elements are enabled
5°C
Power Res
% power of each supplementary heater step compared with the
machine 100 % value
0
Set Ta CP
Setting in comparison with the external air. Below this value,
compressors will be disabled if P.C. supplementary heaters are
present.
-5 °C
Numb. of pumps
Total number of evaporator pumps
0
Numb. of pumps
ON
No. of pumps switched on at the same time.
0
In/Out H20
Temperature regulation selection on the water inlet/outlet
IN
Time Int
Integration time (integral error calculation) for regulation in water
outlet.
600
CP1-CP2B
Compressor override mask if the power limit control is active:
CP1-CP2-CP1A-CP2A-CP1B-CP2B
111111
V.max FC
Maximum DCP voltage in freecooling
10V
AG pump
Enabling of the pump powering up as antifreeze protection together
with the evaporator electrical elements.
OFF
MultiTRIO
Enabling at the multichiller control (network control of more than
one chiller with master and slaves)
OFF
Language
Language selections used: Italian, English, German, and French
- - -
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Aermec GR3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info