782361
33
Zoom out
Zoom in
Vorherige Seite
1/136
Nächste Seite
SCOOPY+ S - User Manual
27
2.4. Auxiliary transmission functions
The main function of the SCOOPY+ S is the transmission of one or two audio channels, but it also provides
auxiliary functions for transmitting additional data, inside the same stream (or, more generally, the
same session).
Exchange of binary data with the remote codec during transmission: sending and receiving two
Boolean states "INFO1" and "INFO2". On the receiving direction these states are shown on the
front panel, and can close relay contacts (GPO), found on the "EXTENSION" connector of the
SCOOPY+ S. The transmitted states can be set by GPI contacts on this same connector, or
alternatively by keys on the front panel. A typical application is the transmission of an "On Air"
signal. See operation details in 3.2.1 and 4.4.7. This feature is not available through a mobile
voice link.
Exchange of additional "INFOn" states, up to 4 signals. Using these is possible if complementing
the SCOOPY+ S with a GPIO extension box, available as an accessory. This box provides 4 GPIO
isolated inputs and outputs. See operation details in 4.4.7. Only an IP network (Ethernet or
mobile) can support such additional transmission.
Receiving SMS from the mobile network, available when the "HD-4G Mobile" option is installed
and as soon as the unit is registered on a mobile network. The PIN code of the SIM card must be
entered beforehand. When receiving an SMS (sent to the SIM card's subscriber number), the
message is displayed directly on the front panel, and it can be read as well from a page of the
embedded html server of the unit. This function is independent from the transmission link(s).
"In-band" exchange of information ("RC data" in the table below): this function allows a remote
unit to remote control the SCOOPY+ S via a running ISDN link. This control mode uses the
dedicated AARC protocol. This additional transmission exists only over ISDN and excludes
INFO1/INFO2 exchanges).
These various features are only compatible with AETA products, because they are not inside the
scope of independent standards. Besides, for using them they must be activated on the remote unit
as well.
The availability of these functions depends mainly on the transmission network. The following table
summarizes the capabilities.
Table 5 Auxiliary functions depending on the network used
Besides, over ISDN links auxiliary data transmission is only available for the following coding algorithms:
G722-H242
MPEG Layer 2 with J52
4SB ADPCM
INFO1 / INFO2 INFO3 to INFO6
ISDN
IP
POTS
Mobile voice
Network
Transmission
SMS
RC
data
33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Aeta Scoopy plus S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info