When the cooker is in use, the temperature control knob (B) (See Fig. 2) should be between 6
and 7 on control knob with numbers (See Fig. 3) or in mid-section of green band on control knob
with green band graphics (See Fig. 3A), with the indicator on or about the centre of the silver
section of the heat indicator (See Fig. 15). It may be necessary to adjust the temperature control
knob slightly to achieve this.
NOTE: FOR MODELS WITH NUMBERED GRAPHICS ON CONTROL
KNOB ‘B’. (SEE FIG
. 3)
CAUTION: BEFORE LIGHTING: ENSURE KNOB (A) IS IN THE OFF POSITION (SEE FIG. 4).
ALSO ENSURE GAS SUPPLY TO COOKER IS ON, AND THE SERVICE GAS COCK (C) IS
IN THE ON POSITION (SEE FIG. 2), AND THE ELECTRICAL SUPPLY TO THE AGA IS
SWITCHED ON.
LIGHTING PROCEDURE - SEE FIGS 3 - 8
1. The main burner gas flow is set with the ‘temperature knob’ (B) (See Fig. 3). Position ‘1’
is the minimum and position ‘7’ is the maximum temperature setting. First ensure
knob (B) is turned fully clockwise to position ‘1’.
2. Turn ‘ON/OFF’ knob (A) slightly anti-clockwise towards the ignition position ( ) until
reaching stop, press down and hold for 5 seconds (gas flows only to the pilot burner). (See
Fig. 5).
3. Continue pressing down knob (A) while turning further anti-clockwise to the PILOT position
(See Fig. 6) (this activates the piezo) continue to hold down for 10 seconds after pilot burner
has been lit (if the pilot does not light, steps 2 and 3 can be repeated).
4. Upon lighting, release knob and turn further anti-clockwise to the ‘ON’ position (large flame
symbol) (See Fig. 7). Pilot gas flows and mains gas flows according to the temperature
setting (knob B).
5. Turn the temperature knob (B) slightly anti-clockwise to position ‘2’ (LOW FIRE position) (See
Fig. 8A). Leave in the low fire position for at least 30 minutes.
NOTE: Low fire may be between positions 1 and 2. Turn knob until small flame is observed
through viewing window (D).
6. After 30 minutes rotate control knob (B) anti-clockwise to between positions 6 and 7 for
normal running (See Fig. 8B).
NOTE: After several hours the temperature of the cooker can be monitored by the heat indicator
Setting 6 to 7 should bring the indicator to the centre of the silver section. It may be necessary
to adjust the control knob slightly (between 6 and 7) to achieve this.
When the cooker is lit from cold, moisture may form on the enamel which should be wiped off to
prevent staining.
IF THE FLAME HAS EXTINGUISHED FOR ANY REASON, WAIT THREE MINUTES
(MINIMUM) BEFORE RE-LIGHTING.
AUTOMATIC CONTROL
TO LIGHT THE BURNER
6
