The EXTRA HOUR button will only work in the AUTO,
ONCE and OFF modes. It will NOT work in the CONT
mode. To change the mode, press the button marked ‘A’
for Cooker and ‘B’ for Heating in Fig. 8. Each time you
press the button it will move through the list of modes
above it.
Changing from AM/PM Time Display to the
24 Hour Clock
Your programmer can operate on the 12 hour AM/PM or
24 hour clock formats. To change the format, ensure the
slider is in the RUN position and then press and hold the
and buttons together for about 2 seconds.
Ignore the ‘NOT VALID’ message that will appear briefly.
All the displayed times will be automatically changed to
the new format.
Repeating this procedure will change the clock display
back to the original format.
Changing the Installer Parameters
The programmer has a special Installer Mode where
some features can be adjusted to suit your lifestyle or
preferences - these are called Installer Parameters, and
are listed in the table overleaf, along with a description of
the options that are possible.
To Enter Installer Mode
a. Ensure the slider is in the RUN position, then press
and hold and buttons together for 8 seconds.
Ignore the ‘NOT VALID’ message that is displayed for
a few seconds. The message ‘SET UP MENU’ will
show briefly, followed by ‘SET INSTALLER OK?’.
b. Press the button to take you into the Installer Mode
Parameter Menu.
c. Parameter 1 is now available to change. This is to
allow you to change the clock format from 12 hour
AM/PM to 24 hour. At every step the Electronic Display
will inform you what the parameter means and what
option you have selected.
The parameter number is shown on the display separated
by a colon from the parameter value.
d. You can change the parameter value by pressing the
or buttons . At this point the description in the
Electronic Display will change and the parameter
value will flash. If you press the value will stop
flashing and be saved for use.
e. Press to move to the next parameter available for
editing.
f. Keep pressing to step around the list of parameters,
and use or buttons to change the parameter
value.
g. Any parameter changes that have been confirmed with
the button will be saved and used.
To Exit Installer Mode
h. You can exit Installer Mode at any time by moving the
slider to the next position and then back again to RUN.
NOTE: The Installer Mode will exit automatically after 10
minutes if the slider is not moved.
Fig. 9 DESN 516084
FINE TUNING YOUR PROGRAMMER
14
