Thank you for buying a Rayburn Appliance. To get the best from it, please read the following and carefully follow the
instructions before using your Rayburn for the first time.
Consumer Protection
As responsible manufacturers we take care to make sure that our products are designed and constructed to meet the
required safety standards, when properly installed and used.
IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING WARRANTY.
Any alteration that is not approved by AGA could invalidate the approval of the appliance, operation of the warranty and
could affect your statutory rights.
Health and Safety
See Installation and Servicing Instructions for details.
The Appliance
Your Rayburn has been designed to provide cooking, central heating and domestic hot water when you require it. It can
be run as an on/off cooker.
The boiler side of your Rayburn should not be set to run below 60°C.
If the weather is very cold, or if you prefer, the appliance cooker burner can be run on a continuous low or high setting as
required. Do not use to warm a room with the appliance doors left open.
DO NOT LEAVE THE ROASTING OVEN DOOR OPEN - If left for any length of time over-heating may cause damage to
some components within the appliance.
This Rayburn is for use with Kerosene Class C2 to BS 2869.
This appliance must be commissioned by an approved engineer.
A Rayburn programmer is supplied as an integral part of the appliance and allows the cooking and heating functions to be
used separately or together.
Two independently fired oil burners are fitted. These are:-
1. The boiler burner which gives domestic hot water and central heating or domestic hot water only, dependent upon
external controls fitted.
2. The cooker burner gives control of hotplate and oven temperatures.
Your Rayburn comes complete with:-
1 Meat Tin 1 Grill Rack 1 Commissioning Letter
1 Solid Shelf 2 Grid Shelves 1 Servicing Instruction
1 Wire Brush 1 Cookbook 1 Installation Instruction
3
INTRODUCTION
USER INFORMATION
