Bedienungsanleitung Aga Rayburn 680 (Seite 9 von 16) (Englisch)

729483

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

The temperature of the hot water supplied can be

adjusted by means of the boiler thermostat knob. This

knob can also be used to turn the boiler off.

To inhibit internal corrosion of the boiler heat exchanger it

is important not to operate the boiler below 60°C.

An ideal setting for summer hot water; and to keep the

temperature above 60°C, can be achieved using the

‘ECO’ setting.

‘ECO’ SETTING

The ‘ECO’ setting on the boiler is a range at which the

boiler operates at maximum efficiency.

The boiler thermostat knob is situated behind the control

door (See Fig. 2). Turn the knob clockwise to increase the

temperature of the water.

Should your heating water system be of an unvented

design i.e. Pressurised System. It is important not to keep

resetting the boiler safety cut-out as this may indicate a

loss of secondary water.

Check also your system pressure gauge.

FROST PRECAUTIONS

In the event of the boiler being OFF for long periods

during very cold weather, the advice of your installer

should be obtained.

THE BURNER

If a fault occurs on either burner then a fault code is

displayed and shuts down the part of the appliance with a

fault (cooker or boiler).

This can be re-set after 1 minute by pressing the REPEAT

button.

In the event of repeated failure switch off the oil and

electrical supply to the appliance and contact the installer/

service engineer.

WHAT IT DOES

The Rayburn programmer is a 7-day 2 event programmer

which allows the user to set 2 periods of the day in which

the cooker will turn on and then off, A typical example

of how this may be used is ‘on’ for use in the morning

and then ‘off’ when going out, and then ‘on’ if needed for

cooking later in the day and then ‘off’ when cooking is

finished.

The programmer can be set for different time each day

(e.g. morning and evening). However, as many people

have a similar routine through the working week, there

is a repeat function which allows the setting from the

previous day to be copied.

However, it may still be set each day differently.

FUNCTIONS

The AUTO/MAN functions allow the user to turn the

cooker on, by simply turning the knob to the required

cooking mark temperature, or by having it turn on at 2 set

periods within the day.

The minute minder function works as a countdown timer

to ease with cooking. When the timer has counted down

the display will flash 00:00 and a buzzer will sound.

SETTING INDIVIDUAL DAYS

To allow the user to change an individual day without

having to run throughout the entire week, there is the

ability to change just one day (e.g. days holiday) without

altering the previous settings.

1. Press the CLOCK button once. Adjust the day using

+ and -. Press the CLOCK again.

2. Adjust the hour using + and -. Press CLOCK again.

3. Adjust the minutes using + and -. Press CLOCK to

confirm.

The day light will go out

PLEASE NOTE: Hold + and - down to increase or

decrease.

THE BOILER THE PROGRAMMER

SETTING THE TIME OF DAY

: flashes when time is set

Fig. 5 DESN 514714

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aga Rayburn 680 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info