Bedienungsanleitung Aga Rayburn 680 (Seite 13 von 16) (Englisch)

729483

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

BURNER RESET

OIL LEAK OR FAULT

POWER FAILURE

FUEL

VENTILATION

SERVICING

Fig. 14 DESN 515775

BOILER BURNER

RESET BUTTON

COOKER BURNER

RESET BUTTON

FAULT INDICATOR

Reset buttons are located behind burner door. The

cooker burner, under normal conditions will flash every 15

seconds. This is part of the system monitoring.

The boiler burner does not flash.

If a fault occurs on either burner then it automatically

shuts down and the red button on the burner control box

will be illuminated.

OPERATE BY PRESSING WITH FINGER ONLY.

Please wait at least 60 seconds between resetting the

lockout button.

If for example the storage tank has been replenished

after the oil supply tank ran out, and resetting the lockout

button does not light the burner immediately, it will be

necessary to repeat the sequence.

Continued lockouts indicate a burner or oil supply

malfunction. The fault should be diagnosed and rectified.

In the event of repeated failure switch off the oil and

electrical supply to the appliance and contact your

installer/service engineer.

If an oil leak or fault exists or is suspected the unit must be

isolated from the oil and electrical supply. The appliance

must not be used until the fault has been rectified.

In the event of power failure your appliance will become

inoperative. When the power is restored it will automatically

restart, if programmed or manually set to do so.

Please endeavour to see that when your fuel is being

delivered into your storage tank, that the appliance is left

off during delivery, and preferably for a period of 1 hour

afterwards to allow sediment within the tank to settle.

This is particularly important for the oil system using two

pipe flow and return.

Also endeavour to avoid running out of fuel, by seeing

that the storage tank is replenished in good time. This

will help avoid nuisance breakdowns which can result

through fuel starvation.

Please see that the permanent ventilation provided for

the safe and reliable operation of your Rayburn is never

blocked off.

With normal use a boiler/cooker annual flueway clean and

burner maintenance should be carried out immediately

before the end of the heating season.

An additional flueway clean halfway through the heating

season may be necessary in some cases - see servicing

instructions.

A HOT APPLIANCE CANNOT BE SERVICED.

Both cooker and boiler thermostats knobs should be

turned OFF, the night preceding the day of the servicing

so that the appliance will have cooled down by the

following morning.

This product MUST be serviced at regular 12 monthly

intervals to optimise its safety, efficiency and performance.

Should a problem arise with the cooker or boiler, an alarm

or an error code fault will be displayed, on the RH side for

the cooker and the LH side for the boiler.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aga Rayburn 680 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info