Usage and Maintenance Instructions Ver. 1 01/2013 (2555)
3
To extend the ramp to its full length, continue to pull the narrowest
section of the ramp whilst pressing the button situated on the outside
of the ramp. Do this until the section is locked in position.
Repeat this for the other ramp.
TO RETRACT
Position the narrowest section into the main body of the ramp. Do this
by pressing the button whilst pushing the narrowest section into the
body of the ramp.
To complete the retraction operation, continue to push the narrowest
section into the body of the ramp whilst pressing the button. Do this
until the ramp is locked into position.
Repeat this for the other ramp.
MAINTENANCE & SAFETY
Regularly check your ramps for worn, loose or damaged parts – If you
find any of these to be damaged you must not use your ramps and
you must contact your dealer immediately.
Always use both ramps, and ensure they are level and parallel to each
other.
Ensure ramps are fully extended and locked in position.
Do not attempt to use ramps at a gradient above 1 in 12. Please also
check the gradient your wheelchair or scooter is capable of.
Do not exceed the weight capacity of the ramps.
Only allow one person/ mobility vehicle to use the ramps at once.
The surface of the ramps may become slippery in icy or wet
conditions. Please exercise caution in these conditions.
Keep your ramps clean of any dirt or debris as this could interfere with
its sliding motion.
Always use the ramps in line with the wheelchairs/scooter
manufacturer’s guidelines; NEVER use it at a steeper gradient than
recommended.
Do not modify or add to your ramp as it could void any warranty
claims.
Do not use the ramp for anything other than its original intended
purpose.
Only clean your ramps with mild detergent.
Use caution when adjusting the length of your ramps and avoid any
pinch points.
