Bedienungsanleitung Airpress 34250 - 600 plus (Seite 17 von 32) (Deutsch, Englisch, Holländisch, Französisch)

593925

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

■ Compressed air is an energy fluid and therefore potentially dangereous. The

pipes carrying compressed air must be suitable fixed especially rubber hoses;

if not property fixed they can cause damage or hurt somebody. Do not pull

rubber hoses to try and move the compressor.

■ Do not weld or make any modifications whatsoever to the tank. If you find

some defects, air leak or corrosion the unit must be returned to the Service

Centres for a replacement to be fitted.

■ Never aim compressed air towards people or towards your body and

remember that the use of protective glasses is necessary for protecting the

eyes from dust and other particles moved by compressed air.

■ The use of compressed air in its applications (tyre inflation, pneumatic tools,

spray painting, washing, detergent washing etc.) must comply with the

relevant regulations for the individual cases guaranteeing the minimum

distance of 4 meters between the working area and the compressor.

■ Compressed air from a compressor can not be used for pharmaceutical, food

or health uses without further treatment. Do not use the compressed air to fill

the cylinders for breathing/diving apparatus.

5. START UP AND USE

- Connect the flexible hose to an external air receiver of suitable capacity for

the size of compressor and to reduce air consumption.Check the information

on the data plate with the specifications of the installation (voltage can

fluctuate by +/-10%).

- Check the oil level on the sight glass and if low refill through the oil filler. If

the oil level is below the minimum allowed, damage can occur to the pump, if

it exceeds the maximum oil is passed into the air supply.

- Turning the machine on and off must be done by using switch positioned on

the frontal panel, failure to do this would damage the compressor.

- The motor is supplied with thermal overload protection, this is placed in the

terminal box of the motor. They have manual reset, set when the machine

are tested, the setting must not be changed. A red warning light will show

that the protection must be re-set.

- When the machine is first installed and on each subsequent electrical

installation, it will be necessary to check the direction of rotation of the motor

and check the air inlet and outlet.

- Position the compressor at least 50 cm away from the wall and with good

ventilation around it, so that cool, clean air flows through the fly-wheels and

around the motor. If the compressor is located in a small room, it is

recommended to duet air from outside. It is important for the cabinet to be

closed for proper ventilation of the machine. On the two-stage compressors

the air compressed during the first stage at 4 bar pressure is cooled through

an intercooler into the final stage. For correct lubrication install the machine

on a level surface.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Airpress 34250 - 600 plus Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info