Bedienungsanleitung Airpress 36553 (Seite 26 von 60) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

594002

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

• Check that the electric circuit is adequately protected and that it corresponds

with the power, voltage and frequency of the motor. Check that there is a

ground connection and a regulation differential switch upstream.

• Use cables with an adequate section and avoid use of free and inadequately

insulated connections.

• Never open the pushbutton box on the motor. Should this be necessary,

contact a qualified electrician.

• Make sure that the machine and the cable never come in contact with water.

• Treat the power cable with care. Do not attempt to move the machine by pulling

the cable. Do not yank the cable to unplug it; keep the cable away from

excessive heat, oil and sharp objects.

• Never leave the machine unattended with the power supply "on". Also

disconnect the power cable when:

- you leave the machine, even for a short time

- not in use

- carrying out maintenance work

- changing attachment or moving the machine.

• WARNING: the warnings, cautions and instructions discussed in this

instruction manual cannot cover all possible conditions and situations that

may occur. It must be understood by the operator that common sense and

caution are factors which cannot be built into this product, but must be

supplied by the operator.

• Only those persons who are aware of how to use the compressor by having

read this manual, should use the machine. Injudicious use may cause danger.

3.0 PLACING

The AIRPRESS compressor should be placed in such way that all points, destined

to carry it will really do so. Take also care of a horizontal position.

The engine should get sufficient cooling air; so never cover the ventilating

openings. Place the compressor in a cool dustfree space. Never place the

compressor in a room where will be sprayed. Paint spray will clog the air filter and

will also deposit on the compressor. Mind that the drain tap for condensation water

(l) and the level gauge will always remain attainable. We suggest to leave a space

of approximately 30 cm for ventilation and maintenance.

Notice: Insufficient air supply, too high temperature and fouling of the air

filter reduce the efficiency of the compressor considerably (H 85 without air

tank and drain tap for condensation water).

3.1 ELECTRIC CONNECTION

At the factory the machine is already fully equipped with cables. The machine now

has to be connected to your own electricity supply. Connect the machine to a

separate group. Beware that voltage and amperage of your electric circuit meet

the needs of the motor. Use only cables with the right diameter. The factory

suggests to use cables of at least 2.5 qmm.

It is well advised to place a main switch between the compressor installation and

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Airpress 36553 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info