28960
58
Zoom out
Zoom in
Vorherige Seite
1/63
Nächste Seite
58
COMPENSATION MIXERS (C-Mix)
The RD6000 Sport has two compensation mixers available to handle advanced mixing needs. These are in addition to
the predefined mixers. Compensation mixers C-Mix 1 and C-Mix 2 are only available in the Aircraft mode of operation
and do not have any switch to turn them on or off when activated.
The purpose of a Compensation Mixer is to allow one transmitter control input to affect two flight functions. A
common mix would be Aileron to Rudder to achieve coordinated turns without moving the rudder stick. However, the
RD6000 Sport provides a predefined mixer for this function.
Press the (CH+) key to move across the CH indicator and access the “etc” screen. Next press the FUNCTION down
key and locate the following screen names in order:
MAS 1: EL = (C-Mix #1 Master channel) example EL “Elevator”
SLV 1: EL = (C-Mix #1 Slave Channel) example EL “Elevator”
E>E 1: 0% = ( C-Mix #1 mixing percentage) Adjust from +150% ~ -150% example “Elevator to Elevator”
MAS 2: EL = (C-Mix #1 Master channel) example EL “Elevator”
SLV 2: EL = (C-Mix #1 Slave Channel) example EL “Elevator”
E>E 2: 0% = ( C-Mix #1 mixing percentage) Adjust from +150% ~ -150% example “Elevator to Elevator”
NOTE:
At this point, both C-Mix 1 and C-Mix 2 are not activated (factory default).
To activate both C-Mix 1 and C-Mix 2 you must first change the (SW-R) from NOR (normal) to REV (reverse). See
page number 27 on how to change.
REMEMBER:
When you activate both C-Mix 1 and C-Mix 2, they both will be on all the time, there is no toggle switch to turn them
off or on. Any number besides “0” in the percentage screen will cause the slave channel to move in either direction.
Changing the SW-R (switch reverse) will also change the switch direction or both your Dual Rate switches and will
reverse the direction of your Gear and Flap switches. If you have setup any of the features mentioned, please review
your settings before flying.
In the following example, I will use C-Mix 1 to mix Rudder to Elevator as maybe needed for knife edge flight.
Start by pressing the (CH+) key until you reach “etc” .
etc
58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Airtronics RD6000sport wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info