Bedienungsanleitung Aiwa CDC-X517M (Seite 4 von 10) (Englisch, Französisch, Spanisch)

496625

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

CDCX517MX417/X317(YU)-total-En-4

ENGLISH

Adjusting sound

You can select the following modes for adjusting sound

depending on the music you listen to: BASS (low

frequencies), TRE (high frequencies), BAL (left/right),

FAD (front/ rear) and H-BASS (high bass)

1 Press SEL repeatedly to select the mode to be

adjusted.

Pressing SEL cycles through the modes. The

selected mode’s indicator flashes.

2 Turn the Smart Jog to increase or decrease the level

for the selected mode (except for H-BASS).

In H-BASS mode, turn the Smart Jog to select on or

off.

Note

Adjust the level or select on/off within 5 seconds, or the

selected mode will return to previous state.

Aligning the source levels

(Source Level Adjuster)

Volume may vary each time you change the source

mode. In this case, you can align each source mode’s

volume to almost the same level.

1 Press FNC repeatedly to select the desired mode.

2 Press DISP while pressing SEL.

“LA 0” appears in the display.

3 Turn the Smart Jog to adjust the level.

Note

Adjust the level within 5 seconds, or the selected mode

will be canceled.

Restoring the factory settings

1 Turn off the unit.

2 Press and hold DISP until “LA --” appears in the

display.

Note

You can restore the factory settings only for VOL, BASS,

TRE, BAL, FAD, and H-BASS, and aligned source

volume levels.

Muting button beep sounds

1 Turn off the unit.

2 Press and hold SEL until “bEEP” appears in the

display.

3 Turn the Smart Jog to select on (level indicators

appear) or off (level indicators disappear).

4 Press and hold SEL until the unit turns off.

Stereo indicator

Local indicator

Setting the clock

1 Press and hold DISP until the clock indicator flashes

in the display.

2 Press TUNEi (to set hour) or TUNEk (to set

minute) and turn the Smart Jog.

3 Press DISP.

Displaying the clock

1 Press DISP.

To return to the former display, press DISP again.

RADIO OPERATION

Tuning in to a station

(Seek/Manual Tuning)

Band indicator Frequency indication

1 Press FNC repeatedly to select the desired band

(FM1, FM2, FM3, AM1 or AM2).

2* Press TUNEi (to move to higher frequencies) or

TUNEk (to move to lower frequencies) to tune in to

a station.

“ST” appears in the display when a station is

broadcasting in stereo, and receiving conditions are

good.

*Seek Tuning and Manual Tuning

• Press and hold TUNEi or TUNEk until seek Tuning

starts.

The unit locates a station automatically (Seek Tuning).

• Press TUNEi or TUNEk repeatedly to search for a

desired station while increasing or decreasing the

frequency step by step (Manual Tuning).

To stop Seek Tuning, press TUNEi or TUNEk

again.

Monaural mode

When signals become weak, or reception becomes

poor, the unit automatically switches to Monaural mode

to reduce noise.

001/CDC-X517M/X417/X317(YU)E 00.12.25, 2:45 PM4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aiwa CDC-X517M Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info