MICROPHONE MIXING
VOCAL FADEFUMULTIPLEX FUNCTIONS
This unit can use discs orta~es as Karaoke sources.
‘ARA”KE-MII
Press the KARAOKE button repeatedly to select the vocal
fader or multiplex function.
Use the vocal fader function for ordinary discs or tapes.
Use the multiplex function for multi audio discs or tapes.
Each time the KARAOKE button is pressed, one of these
functions is selected cyclically.
@ Vocal Fader
A microphone (not supplied) can be connected to this unit,
The singer’s voice becomes softer than the accompaniment.
allowing you to sing along to music sources.
@ Auto Vocal Fader
Use a microphone with mini plugs (03.5 mm,
‘/8 inch).
The singer’s voice becomes softer only while there is audio
input through a microphone.
@ Multiplex
1 Connect your microphone
to the MIC jack.
Only the sound on the left channel is heard from both
speakers, and the sound on the right channel is muted.
MIC
@)Auto Multiplex
The sound on the left channel is heard from both speakers,
and the sound on the right channel is muted only while there
is audio input through a microphone.
@ Cancel
To change the time lag setting in Auto Vocal Fader or ,
Auto Multiplex function
The muted origfnal singer’s voice can be turned faster to the
2 Press one of the function buttons to select the
normal level.
source to be mixed, and play the source.
When Auto Vocal Fader or Auto Multiplex is selected, “A-VF or
“AUTO MPX’ is displayed for 3 seconds and changes to the
3 Adjust the volume and tone of the source.
selected function name. After the selected function name is
displayed; hold down the KARAOKE button until FAST is
4 Turn the MIC VOL control to adjust the
displayed.
microphone volume.
To return to the initial settirtg, select SLOW.
When the power is turned off, SLOW is restored.
To record microphone sound mixed with
source sound
Follow the procedure for-recording from the sound source (see
To change the audible channel in Multiplex function
page 11).
The SYNCHRO DUBBING button cannot be used for mixing
Only the sound on the right channel can be heard from both
recording.
speakers.
When Multiplex is selected, “MPX L-ch” is displayed for 3 seconds
When not using the microphone
and changes to the selected function name. After the selected
Set the microphone volume to MIN and remove the microphones
function name is displayed, hoId down the KARAOKE button
from the MIC jack.’
until MPX-R is displayed.
m
.Toreturn to the initial setting, select MPX-L.
When the power is turned off, MPX-L is restored.
● If a microphone is held too near the speakers, a howling sound
may be produced. In this case, hold the microphone away
m
from the speakers, or decrease the microphone volume.
● The Karaoke functions may not operate correctly with the
● If sound through the microphone is extremely loud, it may be
following kinds of CDs or tapes.
distorted. In this case, decrease the microphone volume.
- Those with monaural sound
Recommended microphones
- Those recorded with strong echoes
The use of unidirectional type microphone is recommended to
- Those with the vocal part recorded on the right or left side of
the sound width
prevent howling. Contact your local Aiwa dealer for details.
● While the Karaoke function is on, the sound is output as
monaural.
