496574
19
Zoom out
Zoom in
Vorherige Seite
1/80
Nächste Seite
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the SOUnCf
levels of the center or surround speakers can
be adjusted during
playback of laser
discs or video software.
1 Press the MANUAL SELECT (TEST) button on the remote
control repeatedly to select “CEN”
(center) or “SLJF?”
(surround).
2 While
the “CEN” or “SUR is displayed, press the DOWN 11<4 ~~
or UP FM button on the remote control to adjust the volume.
a!
ADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 CH LOGIC modes,
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 CH LOGIC mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
If the surround speakers level of the SURROUND is changed
(see pa!]e 7), that of the DOLBY PRO LOGIC is also changed.
About the channels
The left and right speakers create the stereo effect.
The center speaker helps achieve precise sound positioning
over a broad sound field.
The rear-mounted surround speakers enhance the “depth” of
the sound field.
To chi~nge the delay time
The surround speakers reproduce sounds a split second after
the front speakers, The delay is initially set to 21 ms
(milliseconds),
To change this standard delay time, press the MANUAL SELECT
(TEST) button on the remote control repeatedly until “TIME is
displayed. Then, press the DOWN K or UP W button. Each
time olne of the buttons is pressed, the delay time changes as
shown below.
15MS+21MS~30MS
To select PHANTOM or 3 CH LOGIC
Press the DOLBY PRO LOGIC button repeatedly until the desired
Dolby Pro Logic mode is displayed. The Dolby Pro Logic mode
is displayed cyclically as follows,
~ NORMAL+ PHANTOM -* 3 CH LOGIC ,
To adjust the balance of connected speaker sound Ievells
Carry out steps 2 to 4 on page 17.
PLAY WITH DOLBY PRO LOGIC
m
Depending on the sound source and/or listening conditions, a
m
surround effect may not be obtained even when the DOLBY
DOLBY PRO LOGIC
PRO LOGIC is on. -
The full DOLBY PRO LOGIC effect cannot be obtained vvhen
using software without DO~OOL~
SURROUNDI mark. In this case, use
the SURROUND system instead. (See page 7.)
DOLBY
PRO LOGIC
1 Pre!ss the VIDEO/AUX button and start playback
of the video source.
2 Press the DOLBY PRO LOGIC button.
NCWiMALisselected, and the playback sound has the DOLBY
PFio LOGIC effect.
To camcel Dolby Pro Logic mode
Press the DOLBY PRO LOGIC button repeatedly until P-OFF is
displayed.
ENGLISH18
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Aiwa CX-NMT50 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info