157626
10
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
SETTING THE CLOCK
m—
-m
When the AC cord is connected for the first time, the time on the
display flashes.
Set the time as follows
while the power is off.
1
2
3
4
5
Press the SET button.
The hour flashes.
Press the 1<+ or >[ button to designate
hour.
Press the SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the l++ or >1 button to designate
minute.
the
the
Press the SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To correct the current time
Press the POWER button to turn the unit off and press the SET
button. Then, carry out steps 1 to 5 above.
To display the current time
Keep the
button pressed until the clock is displayed. The
time is displayed for 4 seconds,
To switch to the 24-hour standard
While the power is on, keep the
button pressed until the clock
is displayed and then press the REPEAT button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption, The current time needs
to be reset,
If power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to be reset.
SETTING THE TIMER
u
<—
c).
.——----
1
The unit can be turned on at a specified time with the built-in
timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
5
Press the TIMER button on the remote control to
display 0, and press the SET button within z
seconds.
O
is displayed, and the hour flashes.
m
If you do not press the SET button within 2 seconds, another
operation may start.
Designate the hour of the timer-on time by
pressing the 1<+ or FPI button, and press the
SET button. Repeat to designate the minute of
the timer-on time.
Select the duration for the timer-activated period
with the l-or >1 button and press the SET
button.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare the source.
To listen to a CD, press the -11 button and load the disc.
To listen to the radio, press the BAND button and tune in to
a station.
Press the POWER button to turn the unit off after
adjusting the volume.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
You cannot set the volume level to 21 or higher,
9 ENGLISH
Downloaded from www.Manualslib.com manuals search engine
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

aiwa-lcx-150

Suche zurücksetzen

  • Bitte ins Deutsche übersetzen, ich kann kein Englisch. Schon alles versucht. Eingereicht am 16-7-2017 16:58

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Aiwa lcx 150 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info