Bedienungsanleitung Aiwa RMD-77 (Seite 6 von 74) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

793979

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

en 10

TURNING ON THE RADIO

Press POWER ON/OFF button to

power on the unit (the display will

bright blue, and the word ON will

appear); press it again to power

OFF (standby mode) the radio (the

display will bright blue, and the

word “OFF” will appear).

KEY LOCK FUNCTION

Press and hold the DISPLAY /

button for two seconds to set the

key lock function.

Once the key lock function is

enabled, the keyboard of the radio

will be lock.

To disable the key lock function,

press and hold for two seconds

the DISPLAY / button.

Batteries must be inserted correctly to avoid damage to the radio. Always remove the

batteries when the radio will not be used for a long period of time, as this will cause

leakage to the batteries and subsequently damage to your device.

BATTERY INSTALLATION

Slide out cover and install

3 AA TYPE batteries in

the numbered order,

making sure to match the

polarity markings inside

the compartment.

BATTERY INSTALLATION

BASIC OPERATION

Note:

• Make sure that the batteries had been installed over the ribbon inside the compartment.

When the batteries need to be replaced, pull the ribbon to remove the batteries

easily from the compartment.

Note:

• The bottom of the antenna can be rotated and stretched.

Note:

• If you are unable to turn on the radio, please check that the batteries were installed

correctly, the battery capacity is sucient and the lock function has not been turned on.

USING THE ANTENNA

TIPS TO IMPROVE RECEPTION

A. For FM/SW broadcasting:

In case of receiving FM/SW broadcasting, fully extend the telescopic antenna, and

adjust its length and direction to get a better reception.

B. For MW/LW broadcasting:

There is magnetic antenna inside the radio. When receiving MW and LW broadcasting,

rotate the radio or change its location to achieve optimum reception.

0kHz DISPLAY

[ ]

DISPLAY

POWER

TUNE INTO STATIONS

Press the POWER ON/OFF button to turn on your radio, then select your desired

band by pressing the FM, M W/LW , SW ( ) or ( ) button. Now, you can turn into your

favorite stations with any of the following tuning methods:

METHOD 1: ETM (EASY TUNING MODE)

ETM skillfully combines a reception circuit of high quality and high precision dial

for easy tuning radio stations.

Using ETM to auto tune and store all available stations into a temporary memory

without eecting ATS nor regular memories, please follow below steps:

1. Press the ETM button to

enter on Easy Tuning Mode.

The display will show the

word ETM.

2. Select your desired band, then

press and hold the ETM button

until the auto scan starts.

The auto scan function will

store all the avalible stations

in the ETM memory.

3. When the auto scan has

stoped the searching, turn

the TUNING KNOB to select

those recently stored stations.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aiwa RMD-77 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info