Bedienungsanleitung Akai AB-40K (Seite 16 von 36) (Englisch, Französisch, Spanisch)

607164

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

MAIN OPERATION

Switching On for the first time

Plug into AC power or install batteries by following instructions on the previous Power Connection

section. Slide the FUNCTION switch to RADIO or CD/USB/AUX position to turn on the unit. The

POWER indicator will be lighted up.

Switching between different sources (Radio / CD / USB / AUX)

After turning on the unit, slide the FUNCTION switch to select different sound sources

Adjusting sound volume level

After turning on the unit, turn the VOLUME knob to adjust the level of sound volume.

Adjusting the rod antenna

The aerial should be extended to ensure good reception in both FM radio modes. It may be necessary to

adjust the position of the unit and /or aerial position to achieve the best signal reception.

Bass booster

During music playback, toggle the BASS button to turn on/off bass booster for bass enhancement.

CARE AND MAINTENANCE

*Carrying for Compact Discs

1. Treat the disc carefully. Handle the disc only by its edges. Never allow

your fingers to come in contact with the shiny, unprinted side of the disc.

2. Do not attach adhesive tape, stickers, etc. to the disc label.

3. Clean the discs periodically with a soft, lint-free, dry cloth. Never use

detergents or abrasive cleaners to clean the disc. If necessary, use a CD

cleaning kit. If a disc skips or gets stuck on a section of the disc, it is

probably dirty or damaged (scratched). When cleaning the disc, wipe in

straight lines from the center of the disc to the outer edge of the disc.

Never wipe in circular motions.

4. This unit is designed to play discs bearing the identification logo as shown here or MP3 format Disc.

Other discs may not conform to the CD standard and may not play properly.

5. Discs should be stored in their cases after each use to avoid damage.

6. Do not expose discs to direct sunlight, high humidity, high temperatures, or dust, etc. Prolonged

exposure or extreme temperatures can warp the disc.

7. Do not stick or write anything on either side of the disc. Sharp writing instruments or the ink may

damage the surface.

Care of the Cabinet

1. To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.

2. The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use caution

when cleaning and wiping the plastic parts.

3. Mild soap and a damp cloth may be used on the front panel.

To Clean the Lens

If the lens get dirty, your player may skip or may not play a CD

1. Open the CD door.

2. Use a camera lens blower/brush to blow on the lens once or twice, brush the dust or particles off the

lens then blow again.

3. To remove fingerprints, use a dry cotton swab to wipe from the middle to outer edge of the lens

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Akai AB-40K Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info