Bedienungsanleitung Akai acac112b (Seite 5 von 8) (Englisch)

168865

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

L (WHITE)

LINE OUT

R (RED)

ANTENNA

CONNECTOR

ISO CONNECTOR

1 3 5 7

2 4 6 8

5 7

4 8

BLUETOOTH ANTENNA

CONNECT TO

EXTERNAL MICROPHONE

TAL K

Notes:

• Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing it lightly

against the unit.

• When you carry the front panel with you, put it in the supplied front panel case.

• Do not press hard or give excessive pressure to the display window of the front panel when attaching it to the unit.

CLEANING THE CONNECTOR

The unit may not function properly if the connectors between the unit and

the front panel are contaminated with dirt. In order to prevent this from

happening, detach the front panel by pressing the button and clean

the connector from time to time.

Clean the connector with a cotton swab together with contact cleaner as

illustrated. Be sure to clean them carefully pin by pin and make sure not

to damage the connecting points.

WIRE CONNECTION

RCA Jack Line Out:

White (left) Red (right)

External Microphone: Black

CONNECTOR A

4. MEMORY +12V

5. AUTO ANTENNA OUTPUT

7. +12V (TO IGNITION KEY)

8. GROUND

Note: (connector A no. 7) must be connected by car ignition key in order to avoid

that car battery being drained when the car will be not used for long period.

CONNECTOR B

1. REAR RIGHT SPEAKER (+)

2. REAR RIGHT SPEAKER (-)

3. FRONT RIGHT SPEAKER (+)

4. FRONT RIGHT SPEAKER (-)

5. FRONT LEFT SPEAKER (+)

6. FRONT LEFT SPEAKER (-)

7. REAR LEFT SPEAKER (+)

8. REAR LEFT SPEAKER (-)

Maintenance

FUSE REPLACEMENT

If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the replacement, there

may be an internal malfunction. In this case, consult your nearest repairing center.

Warning

Use the specied amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.

OPERATING INSTRUCTIONS

1. POWER ON/OFF

By pressing this key, the unit is switched on or off. This unit is turned on by pressing any key.

2. SELECT

3. VOLUME UP/DOWN

Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To select other functions, press the SEL (2)

button shortly until the desired functions is shown on the display. Figure 1 shows how control functions are selected using the

SEL button.

1 3

2 2

Fig. 1 Selection of sound control functions

1. VOL 2. SEL 3. BAS 4. TRE 5. BAL 6. FAD

Turning the VOL knob Right or Left. Increase or decrease the volume by turning

VOLVOL

. These buttons can be used to adjust

the BASS, TREBLE, BALANCE and FADER.

Note: When you press and hold “SEL” key longer than 2 sec, unit enters FUNCTION select mode. In order to exit such mode,

simply press “DISP” key or just wait around for 8 sec. and unit automatically exits.

IN VOL

SEL

2 sec.

SEL

ADJ

SEL

TA VOL

SEL

EON

SEL

DSP

Cotton Swab

Rear of

front panel

Main unit

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Akai acac112b Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Akai acac112b

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info