Bedienungsanleitung Akai APR-C11 (Seite 8 von 10) (Englisch)

62213

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

Precautions & General Maintenance

Place the set on a hard and flat surface so

that the

system does not tilt.

Do not expose the set, batteries or CDs to

humidity,rain,sand or excessive heat caused

by heating equipment or direct sunlight.

Do not cover the set. Adequate ventilation

with a minimum gap of 6 inches between

the ventilation holes and surrounding

surfaces is necessary to prevent heat build-up.

The mechanical parts of the set contain self-

lubricating bearings and must not be oiled

or lubricated.

To clean the set, use a soft dry cloth. Do not

use any cleaning agents containing alcohol,

ammonia,benzene or abrasives as these may

harm the housing.

CD player and CD handling

The lens of the CD player should never betouched!

Sudden changes in the surrounding temperature can cause condensation to form and the lens of

your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens

but leave the set in a warm environment until the moisture evaporates.

Always close the CD door to keep the CD compartment dust-free. To clean,dust the compartment

with a soft dry cloth.

To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free

cloth. Do not use cleaning agents as they may damage the disc.

Never write on a CD or attach any stickers to it.

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

Do not open the set as there is a risk of electric shock.

If you are unable to remedy a problem by following these hints, consult your dealer or

service center.

WARNING: Under no circumstances should you try to repair the set yourself,

as this will invalidate the warranty.

- Problem

Solution

TROUBLESHOOTING

MAINTENANCE & SAFETY

EN-6 EN-7

No sound /power

- Volume not adjusted

Adjust the VOLUME

- power cord not securely connected

Connect the AC power cord properly

-Batteries dead/ incorrectly inserted

Insert (fresh) batteries correctly

Display does not function properly /

No reaction to operation of any of

the controls

- Electrostatic discharge

Switch off and unplug the set. Reconnect

after a few seconds

no disc indication

- No CD inserted

Insert a CD, CD-R or CD-RW

- CD badly scratched or dirty

Replace/ clean CD, see Maintenance

- Laser lens steamed up

Wait until lens has cleared

- CD-R is blank or the disc is not finalized

Use a finalized CD-R

CD/Mp3 disc playback does not work

- CD badly scratched/ dirty

Replace/ clean CD (see maintenance)

- Laser lens steamed up

Wait until lens has adjusted to room

temperature

The CD skips tracks

- CD damaged or dirty

Replace or clean CD

- Program is active

Quit Program mode(s)

Environmental information

We have done our best to reduce the packaging and make it easy to separate into 3

materials: cardboard, paper pulp and expandable polyethylene.your set consists of

materials which can be recycled if disassembled by a specializedcompacts. Please

observe the local regulations regarding the disposal of packaging, dead batteries and

old equipment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Akai APR-C11 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Akai APR-C11

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info