Bedienungsanleitung Akai E2 HeadRush (Seite 11 von 14) (Englisch)

630570

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

LOOPING REC mode

Basic Operation

1. Select LOOPING REC mode by pressing the MODE SELECT switch.

Note: You can also change the mode by pressing both Footswitches simultaneously.

2. Set the LEVEL control to the maximum position by turning it fully clockwise.

3. Tap the right Footswitch (REC/OVER DUB) at the point you want to start the recording. The red LED on the

right lights up and the recording starts.

4. Tap the right Footswitch again, and the red LED on the right turns off and the recording stops. The green LED

on the left lights and the parts you recorded begin looping playback.

5. If you want to over-dub to your recorded sound, tap the right Footswitch. The red LED on the right lights and

over-dubbing starts. You can now record a new phrase.

6. When you tap the left Footswitch (PLAY/STOP), the red LED turns off and over-dub recording stops, and the

recording, with over-dub part, begins looping playback.

This allows you to over-dub record many times by repeating procedures 5 & 6.

About OVER DUB

If you want to do OVER DUB recording, you must drop out of recording before half of the maximum recording time

is used. While you're recording your first part (above procedure 3), the right red LED will start blinking at 3

seconds before half of the maximum recording time is used. If you want to Over-dub a part, tap the left Footswitch

before this LED finishes blinking.

Hints: During Over-dub, if you tap the right Footswitch, it discards the Over-dubbed phrase and retains only your

first recorded phrase.

For example, during a live performance, you can record and play many phrases using over-dub, then after the song

progresses, you can easily return to the first recorded phrase.

Hints: During playback of the looping phrase, if you tap the left Footswitch, the playback will stop. If you tap the left

Footswitch again, playback of the looping phrase will start from the start point.

Hints: If you start the recording and the recording reaches the maximum recording time without tapping the left

Footswitch (i.e. you don't stop the recording), the recording will automatically stop and start looping the phrase.

Fine Setting

In the LOOPING REC mode, only the LEVEL control, LOOP LEVEL switch, and LOOP TIME switch can be used.

LEVEL : Adjusts the output level of the looping sound.

LOOP LEVEL switch

When the LOOP LEVEL switch is set to VARI, it allows you to adjust the output level of the looping sound with the

LEVEL control.

When the LOOP LEVEL switch is set to FIX, the output level of the looping sound is set at the maximum level.

(LEVEL control does not work)

Hints: When you want to change the mode between LOOPING REC and other modes while playing your guitar, you

can change the mode by pressing both Footswitches at once.

But it may be inconvenient since the LEVEL settings are common between LOOPING REC and the other modes.

In this case, as the LEVEL on LOOPING REC is usually set to maximum, you can use the LEVEL control as other

DELAY mode by setting LOOP LEVEL switch to FIX.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Akai E2 HeadRush Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info