630578
8
Zoom out
Zoom in
Vorherige Seite
1/53
Nächste Seite
6
The analog input of the MPC500 is a standard phone jack, while the CD Player’s LINE OUT is most likely a dual RCA jack.
To connect the CD player, you will need two RCA to ¼ inch TS connectors.
2. Make sure the LINE button on the back, between INPUT R and L is in the up position for "LINE".
3. Press the [MODE] button and then [PAD 4] (RECORD).
This brings up the RECORD page.
4. Play the CD. Check the level meter on screen and adjust the recording level using the [REC GAIN] knob.
Important: If the meter goes too far to the right, the sound will be distorted, but if the sound level is too low, the sample will gain
a lot of noise. Set the level as high as possible but not reaching the right edge.
Starting the recording
1. Set the CD player so that it plays the desired sound.
2. Press [DO IT] to begin recording.
Tip: The [12 LEVELS] button also acts as the [DO IT] button.
The MPC500 will be in Record Enable mode, and will wait for an incoming signal. It will start the recording when the CD player starts playing
and a threshold of audio signal is registered. Pressing the [CANCEL] button exits Record Enable mode and resets the MPC500. Pressing the [DO
IT] button a second time will start the recording without waiting for input.
Note: If you press the [DO IT] button wile sound is playing, the MPC500 will start the recording right after you press the [DO IT] button.
The MPC500 will start the recording automatically when the CD Player starts the playback and the bottom of the screen will change as below:
Tip: If the recording level is too low, the MPC500 will not register the incoming audio and may not start the recording when you play the CD. In
this case, go back to step 4 and set the level with the [REC GAIN] knob again.
1. Press the [DO IT] button to finish the recording.
If you do not press the [DO IT] button, the MPC500 will stop the recording when its RAM is full.
2. When the MPC500 finishes the recording, the following screen will be displayed.
3. Check the recorded sample by pressing [PLAY] button.
If you press the [PLAY] button, you can play back the recorded sample until you release the button. If you do not like the recording,
you can remove the recording by pressing the [CANCEL] button.
Assigning the recorded sound to the pad
1. Select the Assign to pad field with the cursor and scroll with the [DATA] wheel. You can also select a pad by hitting it
directly.
The number of this pad will be displayed in the Assign to pad field.
2. Press the [DO IT] button.
This closes this screen and returns to the RECORD page.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Akai MPC500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Akai MPC500

Akai MPC500 Bedienungsanleitung - Englisch - 120 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info