Bedienungsanleitung Al-ko DRAIN 6004 (Seite 9 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

601632

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

− rain water,

− chlorine water (pool water),

− water for domestic use,

GB 2 Translation of original user instructions

− waste water with no more than 5% sus-

pended matter and a grain size of max. 30

mm diameter (submersible pumps, types

Drain only)

Prohibited use

Your submersible pump is not intended for per-

manent operation. The pump may not be used to

pump the following liquids:

− drinking water,

− salt water,

− beverages or liquid foods,

− corrosives or chemicals

− acids or combustible, explosive or gas-

forming liquids,

− liquids with a temperature above 35 °C

− sandy water or water containing abrasives,

− waste water containing textile or paper parti-

cles (applicable for submersible pumps,

types Sub only).

Description of the Pump

Submersible pump (Fig. A)

1 Cable terminal

2 Handle

3 Pump housing

4 Multi-size nipple

5 Elbow connector

6 Suction slots

7 Float switch

8 Electric cable

Function of the pump

The submersible pump sucks the liquid to be

pump-ed into the pump through the suction slots

(6) and pumps it out at the outlet.

Thermal protection

Your submersible pump is equipped with a ther-

mal protection switch which automatically swit-

ches off the pump in case of overheating. The

pump will remain off until it has cooled down.

After about 15 - 20 minutes, the pump will auto-

matically switch on.

Setting up and Operating the

Pump

1. Screw the elbow connector (5) into the pump

outlet.

2. Screw the multi-size nipple (4) into the elbow

connector (5).

3. Attach a hose to the multi-size nipple.

You can cut off the tip of the multi-size

nipple to fit the diameter of the hose you

are using. Using a hose with the largest

possible diameter will greatly improve the

performance of the pump.

4. Uncoil the electric cable completely.

Make sure that any electrical connections

are not exposed to water and do not lie

within the outflow of the pump.

When placing the pump in the liquid,

make sure to let it down slowly. You may

need to tilt the pump slightly so that air

trapped in the body is released. Set the

pump on the bottom so that it cannot fall

over. If the bottom should be sandy or

muddy or rocky and uneven, place the

pump on a suitable hard, flat surface or

suspend it from a rope attached to a

secure object. Make sure to leave ade-

quate room between the pump and the

bottom so that it cannot suck up solid

matter.

Make sure that the pump does not suck in

solid matter. Sand or other abrasive

particles suspended in the liquid will lead

to increased wear and tear and may

impact the performance of your pump.

Before lowering the pump into a well or a

cistern, attach a rope to the handle. When

placing the pump inside a cistern, make

sure that the shaft is large enough for the

pump to fit. For min. shaft dimensions,

see Figure B.

Place a cover over the cistern so that no

one will fall in.

5. Plug the pump into the socket. As soon as

the pump has reached the cut-in (= START)

level, the float switch will automatically

switch the pump on. When the liquid has

fallen below the cut-off (=STOP) level, the

pump will automatically switch off, see tech-

nical data.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Al-ko DRAIN 6004 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info