601550
14
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
en
Startup
14 MH 5065 R
Putting of Weeder Share into Operation
Pull up clutch lever entirely and hold it.
Weeder share will begin to rotate only at the
second half of lever motion.
Breaking of Weeder Share
Loose clutch lever.
Starting reverse drive
Pull up lever for reverse drive as far as it will
go.
Disconnection of reverse drive
Release lever for reverse drive.
Switching off the motor
Set-up saturator lever into position "STOP".
MAINTENANCE AND CARE
CAUTION!
Risk of injury!
Before all maintenance and care, al-
ways switch off the motor and dis-
connect the spark plug connector!
The motor may coast down. After
deactivation, make sure that the mo-
tor is at a standstill!
Always wear work gloves when car-
rying out maintenance on the cutter
blade!
Clean the appliance after every use
Do not spray the machine with water! Pene-
trating water (ignition system, carburettor...)
can lead to malfunctions.
ADVICE
If the machine is inclined to its side, the
carburetor must be pointed upwards.
Professional inspection is always necessary:
After running onto an obstacle
At immediate standstill of the motor
For transmission damage
For defective V-belt
When the cutting blade is bent
When the motor shaft is bent
Refilling of Gear Oil
As a matter of principle, the gear oil should be
changed after 100 operating hours. (oil viscosity
SAE 80).
Oil change
1. Remove brake toe.
2. Remove screwed drain plug.
3. Tilt machine back and suck the oil off by a
pump.
4. Fill in fresh oil. Required oil quantity approx.
0,5 l.
ADVICE
In order to be able to measure the oil le-
vel, the machine has to be tilt back. The
oil has to run out of the feed opening,
shortly before the machine touches the
ground at point A .
5. Close feed opening by screwed drain plug.
Engine
Oil Refilling / Air Filter / Spark Plug
See – Operating instructions delivered by engine
producer.
Setting-up of Bowden cables
Fine setting-up is being made by means of an ad-
justing screw on upper handle and on engine sup-
port (on ends of Bowden cables) .
1. Loose the safety nut.
2. Set up by means of adjusting screw.
ADVICE
Correct Setting-up:Weeder shares can
begin to rotate only in the second half of
lever motion.
3. Tighten the safety nut.
Gas Uptake:
See – Operating instructions delivered by engine
producer.
STORAGE
CAUTION!
Fire hazard!
Do not store fuelled machine in buildings
where the petrol fumes might come into
contact with naked flames or sparks!
ADVICE
Only authorized specialized workshops
or our customer service are allowed to
repair the unit.
Switch the engine off, wait until the weed-
ing shares Stop; unplug the connector of the
sparking plug.
Wear protective gloves when manipulating
the weeding shares.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Al-ko MH 5065 R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info