Bedienungsanleitung Alber e-fix E35 (Seite 93 von 98) (Deutsch, Englisch)

785798

Zoom out

Zoom in

Vorherige Seite

1/98

Nächste Seite

5. Information on driving mode

The driving lever [8] is similar to a car‘s accelerator.

In the initial position the e-fix is stationary. Driving mode starts when the driving lever

[8] is pulled. The speed increases, the further the driving lever is pulled. The maximum

achievable speed is pre-selected by the adjustment wheel [5] and is maximum 6 km/h

forwards, reverse travel is a maximum of 4.2 km/h.

If these speeds are too high for you, your authorised specialist dealer can reprogramme

the maximum speed in the e-fix software.

The electronics in the handle register the movements made by the operators hand. A

slight movement of the lever to the left or the right is converted into a drive command

for the e-fix wheels so that you can drive around bends without a great deal of effort.

Tilting or lifting the wheelchair using attendant control or the additional handle

(optional accessory) is not permitted.

Please observe the information provided by the wheelchair manufacturer on tilting or

lifting the wheelchair.

6. Information on the panic function

If you need to stop the e-fix immediately in dangerous situations then firmly pull the

driving lever [8] beyond the normal detectable limit. This triggers an immediate enforced

shut-down of the e-fix and sounds an acoustic warning signal.

After releasing the driving lever [8], you can immediately continue driving with the e-fix.

7. Removing the attendant control from the wheelchair

•Switch off the e-fix via the control unit (see chapter 5.2.2).

•Remove the attendant control plug [3] from the adapter cable socket [2].

•Release the fixing lever [9] (turn it several times) and remove the attendant control

from the holder on the wheelchair.

Warning

Slight pressure applied to the right or left of the handle of the intu-

itive attendant control results in the wheelchair moving to the right

or left respectively. Equally, it is sufficient to lightly touch the drive

lever to activate it. Therefore always switch off attendant control, if

it is not in use. This ensures that the wheelchair does not begin to

move inadvertently.

Never hang any objects such as handbags, shopping bags, etc. on the

attendant control, whether the wheelchair is in driving mode or not.

Such objects might activate the control lever or trigger the sensors

so that the wheelchair is inadvertently set into motion.

Before inserting the plug [3] into the socket [2], ensure that both

parts are clean and there are no metallic particles on them. If you

detect such particles, use a dry and clean cloth to remove them.

The attendant control plug [3] is magnetic. Therefore prevent the

plug coming into contact with medical implants, electronic storage

media, bank cards or similar items.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alber e-fix E35 Seite 93

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alber e-fix E35

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info