Bedienungsanleitung Alber Esprit E34z (Seite 14 von 51) (Englisch)

785845

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

2.4 Removing the wheels

Usually, both Esprit wheels will remain on your wheelchair at all times. If, for example,

they are removed for transport purposes, this must be done as follows (with the help of

an attendant if necessary):

•If you have not already done so, switch off the control unit (see chapter 5.2.2).

•Ensure that the wheel is engaged (see chapter 2.1).

•If using Alber anti-tippers:

lift up your wheelchair as described in Appendix A of this operating manual and push

down the anti-tippers with your foot.

•If the wheelchair is on the anti-tippers:

press the release mechanism [6] in the centre of the wheel hub (the coupling ring

[7] must not, under any circumstances, be turned at the same time) and pull the

e-fix wheel carefully from the wheelchair.

•Once both wheels have been removed you can return the anti-tippers to their original

position, as described in Appendix A of this operating manual.

•Without Alber anti-tippers:

lift your wheelchair by its push handles.

•Press the release mechanism [6] in the centre of the wheel hub (the coupling ring

[7] must not, under any circumstances, be turned at the same time) and pull the

e-fix wheel carefully from the wheelchair.

•Proceed in accordance with the instructions provided by the manufacturer of your

anti-tippers.

The coupling ring [7] must not, under any circumstances, be turned

while pressing the release mechanism [6] as this can cause damage

to the wheel. It is then no longer possible to remove the wheel.

The Esprit wheel must be engaged in order to remove it from the

wheelchair.

2.5 Transporting and storing the wheels as vehicle luggage

•The wheels should generally remain on the wheelchair and only be removed if abso-

lutely necessary.

•Before removing the Esprit wheels, the control unit must be switched off.

•When setting the Esprit wheels down or aside, take care of the stub axle [9] and the

torque plug [8] on the rear of the wheel. Neither part should be damaged.

•The wheels should be stored or transported on their front or be upright.

•When transporting the wheelchair, follow the instructions in the operating manual for

the wheelchair. You might need to secure the wheelchair or certain components of it.

•During transport, the Esprit wheels must always be secured to prevent them flying

around in an uncontrolled manner to ensure that they do not pose a risk to passen-

gers in the event of a braking manoeuvre.

•Please check whether there are specific regulations regarding the securing of wheel-

chairs and wheels for transport in your jurisdiction; if so, always adhere to these

regulations.

•Alber GmbH and its representatives accept no liability for any damage resulting from

failure to comply with these instructions.

•If you wish to transport your wheelchair in its entirety without dismantling the

wheels, the wheelchair must be protected in accordance with the guidelines and spe-

cifications of the wheelchair manufacturer.

For information about using the wheelchair as a vehicle seat in com-

bination with the Esprit wheels, see chapter 15

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alber Esprit E34z Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alber Esprit E34z

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info