Bedienungsanleitung Alber scalamobil S35 (Seite 16 von 40) (Englisch)

785814

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

2.6 Attaching the scalamobil to the wheelchair

During the instruction session provided by your authorised dealer or an Alber GmbH

agent, you will be shown how to handle and operate the scalamobil and how to

attach it to a wheelchair. The main steps for the attachment of the wheelchair are

described here again in detail.

•Align the two inner drive wheels [15] and the two outer drive wheels [16] of the

scalamobil with each other and carry out a function check (see chapters 2.5 and

2.5.1).

•Place the wheelchair to be attached to the scalamobil on a firm and level surface.

The wheelchair user may remain seated in the wheelchair.

•Apply the parking brakes of the wheelchair so that it cannot roll away.

•Slide the scalamobil as shown in the diagram to the left under the wheelchair.

Ensure thereby that the scalamobil is in a centre position to the wheelchair.

Engage the lower bolts [18] of the scalamobil at the lower brackets [35] on the

wheelchair.

When the lower bolts [18] are properly engaged at the two lower brackets [35] on

the wheelchair, insert the upper bolts [19] into the forks [34] of the upper brackets

of the wheelchair. This can be done in two ways:

2.6.1 Manual insertion

•Swivel the scalamobil upwards. Insert the two upper bolts [19] into the forks [34]

of the upper brackets on both sides of the wheelchair.

•Ensure that the spacer rings [20] on the scalamobil are placed firmly against the

inside of the fork [34].

•Close the two forks [34] of the upper brackets with a quickpin [32] (see chapter

2.6.3). The two upper bolts [19] must be firmly locked in the forks [34] of the

upper brackets.

2.6.2 Insertion with motor power

•Set the speed regulator [27] to a low speed (see chapter 2.3.1).

•Set the scalamobil to “climbing up” mode (see chapter 2.4.4).

•Actuate the driving switch [2] (see chapter 2.4.5); the scalamobil is now slowly

swivelled upwards.

•As soon as the two upper bolts [19] are inserted into the two forks [34] of the

upper brackets on the wheelchair, release the driving switch [2].

•Ensure that the spacer rings [20] on the scalamobil are placed firmly against the

inside of the fork [34].

•Close the two forks [34] of the upper brackets with a quickpin [32] (see chap-

ter 2.6.3). The two upper bolts [19] must be firmly locked in the forks [34].

When using the motor to attach the scalamobil to the wheelchair,

swivel the stair climber only as far as is necessary to engage the two

upper bolts [19] fully in the two forks [34] of the upper brackets,

so that they can be locked with the quickpins [32].

Never swivel the scalamobil beyond this point while the bolts are

unlocked, as the wheels of the wheelchair might otherwise be lifted

off the ground, making it unstable.

To attach the scalamobil to the wheelchair, you must work on level

ground away from the stairs.

35 18

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alber scalamobil S35 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alber scalamobil S35

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info