Telephone base and handset layout
T
T
modular telephone jack, which might look like
the one pictured here, installed in your home. If
you do not have a modular jack, call y
phone company to nd out how to hav
installed.
CAUTION: Use only the power adapter (6V
that came with this unit. Using other power adapters may
damage the unit. Contact your local distributor if you need
to order replacement for the power adapter
Installing the Handset Battery
CAUTION: T
use batteries supplied with this unit, Sanik or Corun AAA
batteries (400mA 1.2V Ni-MH) which are compatible with
this unit.
RISK OF EXPLOSION IF BA
TYPE. DISPOSE OF USED BA
INSTRUCTIONS.
1.
the handset.
2.
compartment, matching the
+
/
-
polarity markings.
3.
upwards until it clicks into place.
4.
light on the handset is on when charging.
Introduction
CAUTION: When using telephone equipment, there are
basic safety instructions that should always be followed.
Refer to the Important safet
guide for more information.
IMPORTANT: Since cordless phones operate on electricity
are suggested to have at least one phone in y
cordless, in case of power outage.
Parts Checklist
Make sure your package includes the items shown below
USER’S GUIDE
Important
• Avoid sources of noise and heat, such as motors, uorescent
lighting, microwave o
sunlight.
• Avoid areas of excessiv
• Avoid other cordless telephones or personal computers.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is
specically designed for wet locations.
• Never touch non-insulated telephone wires or terminals, unless
the telephone line has been disconnected at the network
interface.
• Use caution when installing or modifying telephone lines.
Telephone base installation
Install the telephone base as shown below
electrical outlet is not controlled by a wall switch. If you ha
high speed Internet service, a DSL lter is required (not included).
Contact your DSL service provider for more information about DSL
lter
Please Fully Charge Before Using!
For optimum battery performance, charge the battery for 16
hours before use.
Settings
Ringer Volume
Y
the ringer off
Press UP to increase or DOWN to decrease the ringer volume
when the handset is in idle mode. A beep sounds when the
volume is adjusted to the maximum or minimum level.
Ringer Tone
Y
1. Press PROG when the handset is in idle mode.
2.
3.
4. Press MEM to conrm your selection and a conrmation tone
sounds.
Recall/Flash time
Y
customer calling services such as call waiting service. Y
the recall/ash time to 1, 2, or 3.
1. Press PROG when the handset is in idle mode.
2.
Press 8 to set as 2.
Press 9 to set as 3.
3. Press MEM to conrm your selection and a conrmation tone
sounds.
NOTE: If you are not sure about the correct setting, contact your telephone
service provider for more information.
Dialing mode
1. Press PROG when the handset is in idle mode.
2. Press */TONE to select tone dialing or #/PAUSE to select
pulse dialing.
3. Press MEM to conrm your selection and a conrmation tone
sounds.
Reset
Press PROG followed by #1590# to restore all system settings,
except the phonebook entries, to default settings.
T
line cord
AAA
rechargeable
batteries
User’s guide
Power adapter
W
Modular
telephone
line jack
UP: Press to increase the listening volume during a call; press to
increase the ringer volume when the handset is in idle mode.
DOWN: Press to decrease the listening volume during a call;
press to decrease the ringer volume when the handset is idle.
TALK/END: Press to make or answer a call; press to end a call.
MEM: Press to save a selection during setting; press to enter the
phonebook settings or dial a call from the phonebook.
PROG: Press to enter the setting menu.
REDIAL: Press to call the last dialed number
FLASH: During a call, press to answer an incoming call if you
have subscribed to the call waiting feature from y
service provider
*/TONE: Press to switch to tone dialing temporarily if you are
using pulse dialing service.
#/PAUSE: Press and hold to add a dialing pause when entering
numbers into phonebook.
MUTE: Press to mute a call, press again to resume conversation.
PAGE: Press to page handset.
Battery
Battery
indicator
Flashing
Handset light indicator
Indicator light Status
Flashes every 10
seconds
• The handset battery is being charged
when the power is very low
Flashes slowly • The battery is not connected to the
handset while the handset is put in
the telephone base or charger
• The handset is using alkaline
batteries.
Flashes rapidly • There is an incoming call.
• Progr
is in progress.
• The telephone base is paging
handset.
ON steadily • The handset is on a call.
• The handset is being charged.
Handset T
Battery
compartment
cover
DSL lter (not included)
is required if you
have DSL high speed
Internet service.
u
v
w
x
TALK/END
MEM
PROG
MUTE
FLASH
REDIAL
DOWN
UP
*/TONE
#/PAUSE
PAGE
Making calls
1. Press TALK/END when the handset is in idle mode.
2.
3. Press TALK/END or place the handset in the telephone base to
end the call.
Answering calls
The handset rings when there is an incoming call.
1. Press TALK/END or lift the handset from the telephone base to
answer the call.
2. Press TALK/END or place the handset in the telephone base to
end the call.
NOTE: Press #/PAUSE to temporarily silence the ringer when there is an
incoming call.
Making a call using the redial memory
The last number dialed is stored in the redial memory (maximum
of 24 digits).
Press TALK/END and then press REDIAL .
Other features during a call
Adjusting the listening volume
Y
during a call. Press UP to increase or DOWN to decrease the
volume, a beep sounds when the volume is adjusted to the
maximum or minimum level.
Call waiting
T
your telephone service provider
calls while you are already on a call. Y
alert tone when there is a second incoming call.
1. Press FLASH to answer the second incoming call.
2. Press FLASH to switch between calls.
The light on
the handset
is on when
charging.
Battery
Battery
indicator
Flashing
+
_
www.atlinks.com
A
Alcatel Logo and Alcatel name are trademarks of Alcatel and used under license by Atlinks.
_
+
USER’S GUIDE
www.atlinks.com
ATLINKS Europe, 22 quai Gallieni 92150 Suresnes - France
Alcatel Logo and Alcatel name are trademarks of Alcatel and used under license by Atlinks.
