NOTE :
●
Once you press the digit button, you must complete the following procedures within 5 seconds to
saccessfally complete the procedure.
Remote/ Mobile Unit
2. Press INTERCOM (without letting go) and switch
POWER to ON. The POWER, TEL, IN USE, INT, and
SCRAM indicator will illuminate meaning that your
procedure has been successfully completed.
3. Switch POWER of Remote/ Mobile unit to OFF, and
then switch to ON.
4. Pick up the telephone handset and see if the digit button
flashed is the number you setup.
NOTE :
●
If there is anything wrong in the setting process, please operate the whole procedure from the
beginning to end.
ANTENNA INSTALLATION INSTRUCTIONS
(A) INSTALLATION OF 20M COAXIAL CABLE AND A-7
ANTENNA:
1. Attach the L-type bracket to a bamboo or iron antenna mast as shown in figure
2. Mount the A-7 antenna onto the L-type bracket threading the male cable connector
of the A-7 antenna through the hole located on the L-type bracket. Screw the nut
included onto the A-7 male cable connector to secure the A-7 antenna firmly onto
the L-type bracket.
3. Mount the bamboo or iron antenna mast securely. Run and fix coaxial cable
securely to the antenna mast and connect the female coaxial cable connector to the
A-7 male cable connector When doing this, make a 20 cm loop cable loop for
convenience purposes and then connect the TNC male connector of the coaxial
cable to the TNC female connector of base unit.
14
