Bedienungsanleitung Alecto COA-26 (Seite 19 von 25) (Deutsch, Englisch, Holländisch, Französisch)

633323

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

GB The COA-26 is a CO detector, developed especially to detect carbon monoxide in your

living area.

GENERAL:

What is carbon monoxide?

Carbon monoxide, designated CO, is also called carbon monoxide. It is a colorless, tasteless,

odorless and poisonous gas. ATTENTION this is CO (carbon monoxide) and not CO2 (carbon

dioxide).

YOU CANNOT SEE, SMELL OR TASTE CARBON MONOXIDE

AND IT CAN BE FATAL.

CO is emitted as part of a hot gas mix and therefore it tends to rise until it cools down. This is in

contrast to CO2, which is heavier than air and drops.

All fuel types can produce carbon monoxide.

Most common CO sources:

The most common carbon monoxide sources are (faulty) gas devices used for:

• Heating (Central heating boiler, Geyser, gas heater, portable fuel stoves)

• Cooking

• Vehicles running in an adjacent garage

• Clogged chimneys, smoke ducts or ﬁreplaces

• Fuel-powered tools

• The use of open ﬁre in an enclosed space

The COA-26 does not detect any gases other than CO gas.

Symptoms of carbon monoxide poisoning:

Symptoms of carbon monoxide poisoning are dizziness, fatigue, weakness, headaches, nausea,

vomiting, sleepiness and confusion.

Everybody is sensitive to the dangers of carbon monoxide, experts agree however that small

children, pregnant women and their unborn babies, elderly people and persons with heart or

breathing problems have the highest risk of serious or even fatal injuries. Every year an authorized

installer must inspect and clean your heating system, vents, chimney and smoke ducts.

Important:

• This CO detector is not a replacement for smoke, ﬁre or other detectors.

• The detector must be installed by a competent person.

• This detector cannot protect people with special medical conditions

• This detector might not prevent any chronic health effects of carbon monoxide on the body.

• This CO detector is not a replacement for the correct installation, use and periodic

maintenance of combustion equipment, nor adequate ventilation of spaces in which these

devices are being used.

• We recommend you to weekly test the CO detector using the “TEST/MENU” button on the

CO detector.

• This CO detector only sounds the alarm when carbon monoxide is present at its sensor.

Therefore, it’s possible for carbon monoxide to be present elsewhere and the alarm doesn’t

sound.

• When the alarm sounds, possible harmful carbon monoxide levels are present!

Carbon monoxide can be deadly!

concentration

Period of inhaling and symptoms

50PPM The maximum concentration a healthy adult can withstand in 8 hours.

200PPM After 2-3 hours, mild headache, sensations of weakness, dizziness, nausea.

400PPM Within 1-2 hours, ache in forehead; after 3 hours, life-threatening.

800PPM Within 45 mins, dizziness, nausea, convulsions; Loss of consciousness within 2 hours;

Fatal within 2-3 hours.

1600PPM Within 20 mins, headache, dizziness, nausea; Fatal within 1 hour.

3200PPM Within 5-10 mins, headache, dizziness, nausea; Fatal within 25-30 mins.

6400PPM Within 1-2 min, headache, dizziness, nausea; Fatal within 10-15 mins.

12800PPM Fatal within 1-3 min.

Alarm

When the CO detector sounds the alarm, carbon monoxide (CO) might be present

which can be fatal. Therefore, never ignore this alarm.

When there’s an active alarm, the red

PPM

TEST/MENU

= fout/faute/Fehler/fault

= test/test/Test/test

= gevaar/danger/Gefahr/danger

COA-28

CARBON MONOXIDE ALARM

lees instructies. niet schilderen.

lire les instructions. ne pas peindre.

lesen Sie die Anleitung.nicht Färben.

read instructions.do not paint.

vervang/remplace/Ersetz/replace

exp.07/2020

LED will illuminate, 4 beep tones are emitted

continuously and the display will illuminate. When the carbon monoxide concentration drops below

40PPM, the alarm will stop.

What to do when the alarm sounds:

1. Open doors and windows and immediately do outside into the fresh air. Check whether

everybody has left the building.

2. Call an ofﬁcial installer to inspect the correct functioning and state of maintenance of the

combustion source (gas or oil powered equipment) that could be the cause for the CO

alarm.

3. Only enter the building again after the cause has been resolved and the building has been

well ventilated.

The alarm sound can be switched off by pressing the TEST/MENU button (<150PPM).

If the CO concentration drops, the alarm will eventually stop automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto COA-26 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alecto COA-26

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info