2.3 CAMERA CONNECTION.
Connect the camera to the supplied adaptor and insert the adaptor into a 230V
mains wall socket.
It will now take 30 to 60 seconds for the camera to start-up, which is conrmed by
a beep tone.
Go to the Wi-Fi settings of your smartphone or tablet and select the camera
“Alecto-xxx” Wi-Fi network. This is called Wi-Fi Direct, which is a network without
password.
Now start the AlectoCAM app on your smartphone or tablet.
Press + in the start screen of the AlectoCam app to add the camera.
Now press QR Code (Smart Cong has no function).
The scanner of the smartphone or tablet (if supported) will be activated.
Now scan the QR Code applied to the camera.
or
Press LAN Search and then press the UID code that appears.
The screen Add Device will open and here you can enter the password of the
camera (“admin”).
Now press OK.
It might happen that the camera of the smartphone or tablet is not able to read the
QR code. In this case, press ‘Cannot use QR code’ in the bottom of the screen. In
the eld UID, enter the UID code marked on the QR code sticker and then enter the
password “admin”.
The camera is registered successfully when the image appears. Now press
Camera Settings and select the Wi-Fi network label. Press this button.
The Wi-Fi band will now be scanned and all available SSID names are listed.
You can now select and click your own network. Enter the password of the Wi-Fi
network, press OK and press OK again in the next screen.
Wait a moment until you hear 2 beep tones from the camera which indicates the
camera is now connected to your Wi-Fi router. If this is not the case, please check
whether the correct Wi-Fi password was entered.
