The following messages may be displayed on screen during use, either accompanied by warn-
The connection between the camera unit and the monitor unit has been lost. This may
be caused by the distance between the units being too great, by the camera unit being
switched off or by the camera unit being deactivated as a result of empty batteries.
after this warning is displayed. Connect the mains adapter straightaway to charge the bat-
this warning is displayed. Replace the batteries immediately or connect the mains adapt-
The temperature in the room in which the camera unit is set up is higher than the limit you
set. Take the necessary measures or set a different limit.
The temperature in the room in which the camera unit is set up is lower than the limit you
set. Take the necessary measures or set a different limit.
This message appears just before the system goes into sleep mode. There is now no
longer a connection between the units. The system is only reactivated when the camera
unit detects a sound.
8 TIPS AND WARNINGS
8.1 GENERAL:
• Read the manual carefully and follow all the instructions.
• Never place or use the camera or the monitor in a wet or damp room or environment.
• Make sure that heat can be adequately dissipated; never cover the monitor unit, the
camera unit and/or the mains adapter(s) or place them immediately next to a source of
heat.
• Use only the supplied mains adapter(s); connecting another type of adapter may damage
the electronic equipment.
• Make sure that the adapter cables cannot be damaged and that they cannot cause
tripping or falling.
• Never disassemble the monitor unit, the camera unit and/or the mains adapter(s); this
may only be done by qualified personnel.
8.2 INSTALLATION:
• The mains adapter should only be connected or disconnected when it has been
unplugged from the wall socket.
• Do not install the DVM-70 during a thunderstorm.
• Do not touch uninsulated adapter cables unless the adapters have been disconnected
from the mains power supply.
8.3 FREE FROM INTERFERENCE:
• This Digital Video Monitoring System is digitally encoded. You should therefore never
receive a signal from other equipment, nor will the signal from your camera unit appear
on, for example, your neighbours' monitor.
• If the camera or monitor are located in close proximity to electromagnetic fields, this may
cause some disturbance to the signal (audio or video). In this case, try a different location
for the camera or the monitor or, if possible, remove the source of the interference.
8.4 EAVESDROPPING/INTERCEPTION:
• It is virtually impossible to eavesdrop on/intercept these Digital Video Monitor signals. Not
only would one need to be in range of the video monitor, very expensive equipment would
also be required.
8.5 MAINTENANCE:
• Clean the video monitor with a damp cloth only; do not use chemical cleaning products.
Before cleaning, make sure that the mains adapters are disconnected.
8.6 EXPANSION:
• The DVM-70 system does not allow multiple camera units to be connected to a single
monitor unit, or for the image from a single camera unit to be displayed on multiple moni-
tor units. It is, however, possible to use multiple complete DVM-70 sets side by side at the
same time.
