Bedienungsanleitung Alecto DVM 70 (Seite 17 von 20) (Englisch)

458285

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

8.7 TROUBLESHOOTING:

• In the event that the monitor does not display the camera image and/or the sound is not

being received, check:

- are the monitor and the camera switched on? (monitor unit battery charged up, camera

unit batteries full?)

- is the monitor within the range of the camera?

- has the camera been deactivated on account of silence? (in ECO mode video and

audio are only transmitted when the camera unit detects a sound)

- has the image on the monitor unit been turned off with the button?

- is the volume on the monitor set to 0 (off)?

• If all these things are in order, disconnect the mains adapters from the wall socket,

remove the batteries from the camera unit and the battery from the monitor unit, wait for

around a minute and then put everything back. Switch the monitor and the camera on.

• If you are still not receiving any images or sound, please contact the Alecto service de-

partment on telephone number +31 (0) 73 6411 355.

8.8 RANGE:

• The range of the video monitor is up to 300 metres in the open and 50 metres indoors;

the range is dependent on local circumstances. If the units move out of range of each

other, the image first freezes for a few seconds (no motion), followed after a few seconds

by the message ‘No link’, after which the screen goes black.

8.9 DELAYS IN VIDEO AND AUDIO:

• The camera unit sends the video and audio to the monitor unit in digital blocks. The moni-

tor unit recreates a recognisable image and a comprehensible sound from these signals.

This may mean that there is a short delay between the movement or sound taking place

and seeing/hearing it on the monitor unit.

• In addition, the video and the audio on the monitor unit may not be exactly in sync

with

each other.

8.10 ENVIRONMENT AND DISPOSAL:

• The packaging of this video monitor may be recycled as used paper. We

recommend, however, that you should retain this packaging so that the equipment

can be adequately packed when it is being transported.

• Defective or dead batteries should be taken to your local depot for small chemical waste

or to the special battery collection points. Never dispose of batteries in your

household waste.

• If you are replacing the video monitor, hand in your old equipment to your supplier;

they will ensure that it is recycled in an environmentally-friendly manner.

9 DECLARATION OF CONFORMITY

The Alecto DVM-70 complies with the essential requirements and

provisions as described in European Directive 1999/5/EC. The declaration

of conformity is available on the website www.alecto.info. Usage is allowed in

all countries of the EU. In France, Italy, Russia and Ukraine only indoor use is allowed.

10 SPECIFICATIONS

Range: up to 50m indoors

up to 300 metres outdoors

Power supply monitor unit: 3.7V Lithium Polymer battery (included), made by BYD

6VDC 800mA mains adapter (included), 2.35mm plug

model: MOSO MSP-C0800IC6.0-5W-DE

or HONR ADS-5Q-06 06005GPG

or TEN PAO INTERNATIONAL LTD, S006MV0600080.

Power supply camera unit: 4 x 1.5 V AA battery (not included)

6VDC 800mA mains adapter (included), 5.5mm plug

model: MOSO MSP-C0800IC6.0-5W-DE

or HONR ADS-5Q-06 06005GPG

or TEN PAO INTERNATIONAL LTD, S006MV0600080.

Frequency: 2.4GHz, digital frequency hopping (FHSS) / 52 channels

Display 2.8" colour LCD display

QVGA 320*240 pixels

up to 25 frames/sec, Dynamic Frame Rate

Charging time for monitor unit battery: < 6 hours * (whether the monitor unit is switched

on or off)

Battery life for monitor unit battery: > 8 hours * (brightness set to low)

> 5 hours * (brightness set to high)

Battery life for camera unit with alkaline batteries: > 5 hours *

Temperature sensor range: 11°C - 30°C

Accuracy: ± 2°C (at 25°C)

*: these times are approximate and are dependent on usage and on the condition and quality of

the batteries.

11 WARRANTY

The Alecto DVM-70 comes with 24 months warranty from the date of purchase. During this

period we guarantee that any defects caused by errors in materials or construction will be

repaired free of charge. This at the importer's discretion.

WHAT TO DO: If you notice a defect, first consult the manual. If the manual gives you no

definitive answer, consult the supplier of this video monitor or the Alecto service department on

telephone number +31 (0) 73 6411 355.

THE WARRANTY IS VOID: In the event of improper usage, incorrect connections, leaking

and/or incorrectly installed batteries, use of non-original parts or accessories, negligence and

defects caused by moisture, fire, flood, lightning strikes or natural disasters. In the event of

unauthorised modifications and/or repairs by third parties. In the event of incorrect transportation

of the equipment without appropriate packaging or if the equipment is not accompanied by this

warranty card and the receipt of purchase.

Connection cables, plugs and batteries are not covered by the warranty. Any further liability, in

particular for any consequential damages, is excluded.

Li-poLymer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto DVM 70 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alecto DVM 70

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info