Bedienungsanleitung Alecto DVM-700 (Seite 47 von 52) (Deutsch, Englisch, Holländisch, Französisch)

668917

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

6 TIPS AND WARNINGS

6.1 GENERAL:

• Thoroughly read the user’s manual and follow all indications.

• Never place the baby unit or parent unit in wet or humid room or environment.

• Ensure adequate heat dissipation; never cover the parent unit, the baby unit

and/or the power adapter(s) and never place them directly next to a heat

source.

• Only use the supplied adapter(s); connecting a different type of adapter will

damage the electronics.

• Make sure the adapter cables are free of any damage and ensure nobody can

trip or fall because of these cables.

• Never dismantle the parent unit, the baby unit and/or the power adapter(s);

only qualified personnel is authorized to do so.

• Never rotate the camera by hand; this might damage the engine. Only move

the camera using the control panel on the parent unit.

6.2 INSTALLATION:

• Only connect or disconnect the power adapter to/from the baby unit or parent

unit when the power adapter is removed from the wall socket.

• Never install the DVM-700 during thunder storms.

• Never touch any non-isolated adapter cables, unless the adapters are

removed from the wall socket.

• Make sure that there’s sufficient cable length behind the baby unit for the baby

unit to be able to move freely.

6.3 RECEPTION INDICATOR/OUT-OF-RANGE NOTIFICATION:

• At the top and in the middle of the display the strength is indicated of the

signal transmitted by the baby unit:

4 bars: excellent reception

3 bars: good reception

2 bars: average reception

1 bars: weak reception

• Regardless of the signal strength, the video and audio are reproduced at the

same quality.

• As soon as the parent unit loses the signal from the baby unit (out of range

or baby unit is switched off), the warning ‘Link lost, trying to reconnect...’ will

appear. If the connection is not re-established within 30 seconds, the warning

“Unable to connect, ensure the monitor is turned on and within range” will

appear.

• The display will switch back on as soon as the parent unit is receiving the

signal again from the baby unit.

6.4 DELAY IN IMAGES AND SOUND:

• The baby unit transmits the images and sounds to the parent unit in small

digital blocks. The parent unit converts these signals into recognizable images

and a clear sound. This is why there’s a small delay in between the movement

and sounds of the baby and what can be seen/heard via the parent unit.

• Also the sound and images on the parent unit are not exactly synchronised.

6.5 POWER SUPPLY:

• Baby unit:

The baby unit is powered only by the power adaptor and is not provided with

an internal battery for mobile use.

• Parent unit:

The parent unit is powered by a rechargeable 3.7V Lithium-Polymer battery

which can power the parent unit for 6 to 7 hours.

In the upper right part of the display the battery status is indicator:

battery full (battery colour is green)

battery 3/4 full (battery colour is green)

battery 1/2 full (battery colour is yellow)

battery 1/4 full (battery colour is red)

battery nearly empty (battery outline ashes in red) while alert tones

are emitted; the parent unit will switch off after approx. 30 minutes.

Please immediately connect the adaptor

battery is being charged

It takes approx. 6 hours to recharge an empty battery. Charging is faster when the

parent unit is switched off.

6.6 INTERFERENCE-FREE:

• This baby display monitor is digitally coded. This means you will never receive

signals from other devices, nor can the signal from your baby unit(s) be

received by e.g. your neighbors.

• In case the baby unit(s) or parent unit is placed in or in the close vicinity of

electromagnetic fields, the signal (images or sound) can be slightly affected. If

this happens, try a different location for the baby unit(s) or parent unit or move,

if possible, the source of the interference.

6.7 RANGE:

• The baby display monitor has a range of up to 300 meters in an open field and

up to 50 meters indoors; this range depends on local circumstances.

When the units get out of range from each other, the image will first ‘freeze’ for

several seconds (no motion) followed by the ‘Lost Link’ notification (see also

paragraph 6.3) while the unit emits alert tones.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto DVM-700 Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info