INTRODUCTION
The
radiophone allows for free-of-charge communication
back and forth, as well as communication with other
(Alecto) radiophones as long as these meet the PMR-
446 standard.
The
requirements and provisions as described in the Euro-
pean Directive 1999/5/EC. The declaration of confor-
mity is available on the website www
POWER SOURCE
Install 3 REACHARGEBALE batteries in the FR-27,
size:
1.
back and pushing the belt clip upwards and out of
the radiophone.
2.
batteries as indicated. Pay attention to the correct
polarities (+ and -).
3.
back on the radiophone.
4.
the plug at the rear of the charger)
5.
radiophones on the charger to charge
6. If this is the rst time, leave the radiophone on
the charger for approximately 15 hours until fully
charged.
Y
the adapter behind the rubber cover
When the FR-27 is placed on the charger
on the charger will switch on while the symbol ashes
on the display
switch off when the batteries are charged.
TECHNICAL SPECIFICA
T 446MHz
T 0.5Watt
Channel separation: 12.5KHz
Power supply radiophone: 3,6V (3x rechargeable
1.2V battery)
Power supply charger: 5V
Range: up to 7 Km
Period of use: transmitting: 3 hours
stand-by: 6 days
(based on usage)
Weight radiophone: 77 gr
Dimensions: 92(146) x 50 x 39mm
Conform EN 300 296-2 V1.3.1
EN 301 489-5 V1.3.1
EN 60950-1:+A12:201
Headset connection: 2,5mm stereo
example: Alecto
DISPLA
: shows the selected channel
: battery capacity indication
= batterij OK
ashing
SC
: turns on when the SCAN function is activated
TX: turns on while sending
RX: turns on while receiving
FM: turns on when the radio is turned on
: shows the volume level
: switches on when the key lock is activated
USE
Attention: always set both radiophones to the
same channel
Attention: Don’t forget that other people with a
radiophone can receive your signal also, even
when it’s of a dif
Y
In this case, you can try and select a different channel.
Power on/off:
Press and hold the button for 2 seconds to switch
the FR-27 on or off.
T
Press the PTT button to sending.
(PTT = Push T
Hold the radiophone approximately 5cm from your
mouth and speak into the microphone.
Receiving:
Release the PTT button to receive.
Call tone:
Press the button to transmit a call tone.
Switching channels:
Press the button and then use ▲ or ▼ to select
the correct channel.
Press the PTT button to conrm the selected chan -
nel.
V
Use the button▲ or ▼ to change the volume.
Roger beep:
When you release the PTT button, the FR-27 will
send a tone to inform the other party he or she can
talk back.
This tone is always on and cannot be switched off.
Channel scan:
Simultaneously press and hold and ▲, after 1
second the display will show SC and the FR-27 will
then scan all channels.
Received signals will be shown and the scan will
then continue.
Press the PTT button to stop the scan.
Monitoring:
Simultaneously press and hold ▼ and ▲, after 1
second the display will show RX , the noise reduction
will be switched off and you can also hear the wea-
ker transmissions on the current channel.
Simultaneously hold ▲ and ▼ again for 1 second to
cancel this function.
Key lock:
Press and hold the button, after 1 second the
display will show . Changing channels or the
volume level will now no longer function, but you can
still receive and transmit.
Press and hold the button again for 1 second to
cancel the key lock function.
Headset:
The headset output is located on the right side,
underneath the rubber cover
FM Radio:
Press the button to switch on the radio.
Press and hold ▲ or ▼ to search FM stations for-
wards / backwards.
Press the button again to turn off the radio.
While using the radio, you can still transmit to the
other radiophone by pressing the PTT button. Y
can also still receive signals.
USER TIPS
GENERAL:
• The FR-27 is a transmitter/receiver working with
radio waves on the 446 MHz band. Its signal trans-
mission can be affected by external inuences such
as other radiophones, transmitters, wireless phones,
etc. When your radiophone is being interfered with
or causes interference, simply changing the channel
usually solves this problem.
• The use of this radiophone is permitted in all the
countries of the EU. If you want to bring the FR-27
to countries outside the EU, you should consult the
local restrictions on the use of PMR446 equipment.
• Don’t forget that the signal of the FR-27 can also be
heard by radiophones or receivers other than yours.
• It is in no way allowed to make any changes to the
electronics or the antenna of the FR-27. Service
must be performed by qualied service personnel
only
• Never use the FR-27 outdoors during thunder-
storms.
MAINTENANCE:
• Only clean the FR-27 with a moist cloth.
• Never place the radiophone in direct sunlight or
humid environments.
• Prevent water and/or sand from penetrating the
FR-27.
• In case of any problems, always check rst whether
the FR-27 does work correctly on a different location.
RADIO CONNECTION:
• The FR-27 has an effective range from up to 7km.
This range can be affected by local conditions such
as high buildings, high voltage posts and overhead
wires. -
hone has a clear sight of the receiver
ENVIRONMENT
• When discarding your radiophone, please return it
to your dealer
friendly disposal.
• Y
of these radiophones or to your local collection
point for small chemical waste.
• Never dispose of empty or exhausted batteries as
normal domestic waste.
W
This
months commencing on the day of your purchase.
During this period we guarantee that any defects
caused by errors in materials or construction will be
repaired free of charge. The importer decides upon
these conditions.
WHA
If you note any anomalies, rst read the user
If you cannot nd any solution to your problem, please
contact
073 641
or via internet at www
W
In the event of misuse, improper connection, battery
leakage or incorrect placement of batteries. It does not
cover the use of parts or accessories not delivered with
this device, neglect or any failure caused by humi-
dity
warranty does not cover alteration or modications of
the product by unauthorized qualied service perso-
nal. The warranty terminates in the event of incorrect
transportation of the equipment without appropriate
packaging or if the equipment is not accompanied by
this warranty card and the receipt of purchase.
Cables, jacks and batteries are not covered by the
warranty
Alecto will not be held responsible for indirect, conse-
quential or special damages.
V1.2
FR-27 GB
