Bedienungsanleitung Alecto GA-10 (Seite 9 von 10) (Deutsch, Englisch, Holländisch, Französisch)

794854

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

USE, TESTING AND MAINTENANCE:

USE:

The gas detector is operational if the 9 volt battery is placed and the GA-10 is connected by adapter. You can only place

the detector on the ceiling plate if the 9 volt battery is installed. If the detector is operational the red LED will blink. After

calibration it will turn green.

Once gas is detected, the alarm will go off. A loud beep will sound and the red LED will blink continuously. Once the

gas dissipates, the alarm will stop automatically.

Testing:

By pressing the test key on the GA-10, the alarm can be tested to ensure it is still operational. Hold the key for at least 2

seconds. Operation is correct if the red LED blinks and a tone is audible. Preferably check the detector weekly. During

alarm state, the GA-10 will generate a tone of at least 85dB(A) sound pressure.

Hush function:

With this function, the alarm will be deactivated for 5 minutes. This function can be activated by pressing the button

once, shortly. The red LED will blink to indicate the alarm is silenced. After 5 minutes, the blinking will stop and the

alarm will be reactivated

ATTENTION:

• If there is any doubt over the cause of an alarm, then assume the alarm is caused by a gas leak and evacuate the

premises as soon as possible.

• Keep the gas detector away from small children.

• During renovations, protect the gas detector against dust. It will lose it’s functionality if covered by dust.

Maintenance:

The GA-10 can be cleaned with a vacuum cleaner.

ENVIRONMENT:

Do not throw away used batteries, but recycle them using your local chemical depot. Product may not be thrown out as

normal waste, but must be recycled as electrical waste.

SPECIFICATIONS:

Usage temperature .........................................................................5°C tot 50°C

Power ...............................................................................................12VDC, 200mA 9V DC backup

Alarm point ......................................................................................< 15% LEL

Sound level during alarm ................................................................85dB at 1 meter

PROBLEM SOLUTION

No sound during the test procedure

Note: Hold the test button several

seconds during a test.

1. Remove the detector from the ceiling plate and check if the battery

and adapter is properly connected.

2. Clean the gas detector.

The gas detector beeps every minute Replace the 9V battery and check the adapter.

The gas alarm regularly gives a false

alarm during cooking or during use of

the shower.

1. Clean the gas detector.

2. Move the gas detector to another location.

Green LED blinks every 30 sec. Device not connected on main power, but works on battery.

Red LED blinks The device is still warming up or hush mode is active.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto GA-10 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info