Bedienungsanleitung Alecto WS-5300 (Seite 55 von 60) (Deutsch, Englisch, Holländisch, Französisch)

708531

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

5. ALARM CLOCK

5.1 Introduction:

You may program an alarm (wake-up) time in the WS-5300.

You may then also enable a frost alert; when the outdoor temperature falls below -3°C, the wake-up signal

will sound 30 minutes before the set wake-up time.

5.2 To set the alarm time:

1. press and hold the button at the rear of the weather station for 2 seconds until the hour digits start

ashing

2. use / to set the hours and then briey press ; the minute digits start ashing

3. use / to set the minutes and then briey press ; the alarm time is now set

5.3 To set the alarm function:

1. press the button once or several times to check the alarm or to switch it on/o

Only “AL” appears: the time being displayed is the set alarm time, but the alarm itself is switched o

“AL” + “ ” illuminates: the alarm is switched on and the wake-up signal will sound at the set alarm time

“AL” + “ ” + “ ” appears: the frost alert is set

2. release the button, after several seconds the actual time is displayed and the alarm status, according

to the above description, remains visible

5.4 Operation:

• At the set time, the alarm will sound for up to 120 seconds

• For the rst 4 seconds, the alarm signal has a slow rhythm

• Between 4 and 8 seconds, the rhythm of the alarm signal increases

• Between 9 and 12 seconds, the rhythm of the alarm signal increases further

• After 13 seconds, the rhythm of the alarm signal is the fastest

• Press the button to stop the alarm signal beforehand OR press the SNOOZE button on top of the

weather station to enable the snooze function; the wake-alarm will then sound again after 5 minutes

• The alarm is repeated daily unless you disable it according to the above instructions.

• If you’ve enabled the frost alert “ ” and the outdoor temperature falls below -3°C, the wake-up signal will

sound 30 minutes earlier than the time you’ve set. If the outdoor temperature is above -3°C, the alarm

will sound at the set time.

6. HISTORY

6.1 Introduction:

The weather station of the WS-5300 automatically stores all measurement data of the past 24 hours to

allow you to check the trend of the past 24 hours at any moment

6.2 To view historic data:

1. press the HISTORY button, the most recently stored measurement data is shown in the display includ-

ing the time and date of the concerned data in the upper part of the display

2. repeatedly press the HISTORY button to scroll the memory

The data of the indoor and outdoor temperature and humidity, air pressure, wind chill, wind speed and

rainfall is saved in the history memory.

6.3 To delete historic data:

Press and hold the HISTORY button for 10 seconds to erase all measurement data up to that moment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto WS-5300 Seite 55

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info