Bedienungsanleitung Alex359 Golden Mask 4 (Seite 9 von 10) (Englisch)

654670

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

Golden Mask 4

In reverse order, disconnect the device

from the 220 V network and unplug the jack

from the “CHARGE” socket.

The rechargeable battery could also be

charged using your car cigarette lighter via

a special charging device. Follow the

instructions for use of the specific charging

device.

To ensure maximum battery life:

 do not interrupt the battery charging

before the process is completed;

 recharge the battery when it fully

discharges;

 use only the chargers included in

your metaldetector set.

The charger has the following additional

capabilities:

Indication of reverse polarity or short circuit

in the cable by blinking red light of the LED.

Practical Advice

Keep your metaldetector away from water –

rain or snow can penetrate the electronic

block and the battery holder, and this can

damage your detector!. It is safe to use it on

wet grass because of the hermetical sealing

of the search coil.

Warning:

Do not leave your metal detector on wet

grass or snow to avoid moisture penetrating

the electronic block and especially the

battery holder! During assembly of the

detector in wet or snowy conditions,

avoid moistening the cable plug!

Operating the metal detector in residential

and industrial areas may be hampered by

electromagnetic interference or the

presence of modern iron pollutants. For a

steady operation of the detector, you need

to decrease the power (POWER LEVEL)

and increase the discrimination level (DISC

LEVEL) which, respectively, decreases the

search depth.

Use only quality headphones, preferably

with an in-built potentiometer for audio

adjustment.

After continuous work with the detector and

multiple plugging/ unplugging of the cable

jack into/from the socket of the control box,

it is possible that the connection between

the two deteriorate (when gently touching

the cable jack, the metal detector makes a

sound as if detecting metal). You should

carefully clean the contact surface of the

cable plug with a needle or a fine file. For a

better result, slightly bend inwards all

openings of the cable plug.

Do not switch on the detector when the

outside temperature significantly differs

from the temperature indoors (i.e. in a warm

room). Wait for about 20-30 minutes until

the detector adjusts to the temperature

change before you switch it on.

Do not switch on the detector while the

batteries are being recharged. This can

damage the electronics.

To clean the metaldetector after use,

remove the dust and sand, and wipe with a

damp cloth. Do not use alcohol, petrol,

koresilin and other solvents as they can

damage or remove the symbols on the

control panel. If you operate your

metaldetector on terrains where it is

possible to localize ammunition or other

explosives, take special care while

excavating, because the manufacturer is

not liable for your actions.

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alex359 Golden Mask 4 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info