631108
30
Zoom out
Zoom in
Vorherige Seite
1/80
Nächste Seite
Attenzione:
Durante l'inserimento o la rimozione
della bobina, lago deve essere
totalmente sollevato.
Avvertenza:
Girare l'interruttore su off ("O") prima di
inserire o togliere la bobina.
- Togliere il tavolino da cucito e aprire il
coperchio ribaltabile. (1)
- Estrarre la capsula della bobina tirando
dalla levetta incernierata (a). (2)
- Estrarre la bobina dalla capsula. (3)
- Trattenere la bobina con una mano.
Inserire la bobina in modo che il filo
scorra in senso orario (osservare freccia).
(4)
- Infilare il filo nella fessura e far passare
sotto la maniglietta. (5) Lasciare 15 cm
di filo sciolto.
- Tenere la capsula della bobina dalla
levetta incernierata. (6)
- Accertarsi che la maniglietta della
capsula (b) si innesti correttamente nel
nottolino (c) al limite estremo della pista
come illustrato in (7).
Se la bobina non è correttamente
collocata al punto estremo nella
macchina, non appena si inizierà a
cucire, cadrà immediatamente dalla
spola.
Atenção:
Ao meter ou tirar a bobina, a linha deve
estar completamente levantada.
Nota:
Desligue a máquina ("O") antes de
meter ou tirar a bobina.
- Retire a mesa de costurar e abra a
tampa articulada. (1)
- Empurre a caixa da bobina pelo engate
articulado (a). (2)
- Retire a bobina da respectiva caixa. (3)
- Segure na caixa da bobina com uma
mão. Meta a bobina de modo a que a
linha corra no sentido dos ponteiros do
relógio (seta). (4)
- Puxe a linha através da ranhura e por
baixo do dedo. (5) Deixe uma ponta com
cerca de 15 cm.
- Segure na caixa da bobina pelo engate
articulado. (6)
- Verifique se o dedo do porta bobine (b)
encaixa no nó (c) no topo da lançadeira,
como se mostra. (7)
Se o porta bobina não estiver bem
colocado na máquina, vai cair da
lançadeira imediatamente depois
começar a costurar.
Attention:
When inserting or removing the bobbin,
the needle must be fully raised.
Note:
Turn power switch to off ("O") before
inserting or removing the bobbin.
- Remove the sewing table, then open the
hinged cover. (1)
- Pull the bobbin case by the hinged latch
(a). (2)
- Remove the bobbin of the bobbin case.
(3)
- Hold the bobbin case with one hand.
Insert the bobbin so that the thread runs
in a clockwise direction (arrow). (4)
- Pull the thread through the slit and under
the finger. (5) Leave a 6 inch tail of
thread.
- Hold the bobbin case by the hinged latch.
(6)
- Make sure the bobbin case finger (b) fits
into the notch (c) at the top of the race
as shown in. (7)
If the bobbin case is not properly
placed back into the machine, it will fall
out form the shuttle immediately after
starting to sew.
Inserting the bobbin
PT
EN
IT
Meter a bobina Inserimento della bobina
30
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alfa Style up 40 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Alfa Style up 40

Alfa Style up 40 Bedienungsanleitung - Deutsch, Holländisch, Französisch - 76 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info