Bedienungsanleitung Allen-Heath Xone DB4 (Seite 16 von 44) (Englisch)

541369

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Allen & Heath 16 XONE:DB4 User Guide

THE EQ SECTION

HF CONTROL

Adjusts the high frequency

content of the channel audio. In

ISO or EQ mode the centre-

detent position will give a flat

frequency response, fully

clockwise will boost the high

frequencies by 6dB, and

anticlockwise will attenuate them.

In FILTER mode this control

becomes a low-pass filter, and

must be rotated fully clockwise

for a flat frequency response.

Rotating anticlockwise will

progressively lower the cut-off

frequency of the filter.

MF/RES CONTROL

Adjusts the mid range frequency

content of the channel audio. In ISO

or EQ mode the centre-detent

position will give a flat frequency

response, fully clockwise will boost the

mid frequencies by 6dB, and

anticlockwise will attenuate them.

In FILTER mode this control sets the

sharpness (Q) or resonance of the two

filters. Rotate fully anticlockwise for

low resonance, and fully clockwise for

high resonance. Use this control with

care as a high resonance will boost the

signal level at the Filter cut-off point

which could cause the signal to clip.

LF CONTROL

Adjusts the low frequency content of the channel

audio. In ISO or EQ mode the centre-detent position

will give a flat frequency response, fully clockwise will

boost the low frequencies by 6dB, and anticlockwise

will attenuate them.

In FILTER mode this control becomes a high-pass

filter, and must be rotated fully anticlockwise for a flat

frequency response. Rotating clockwise will

progressively raise the cut-off frequency of the filter.

MODE SELECT SWITCH

Use to select the desired EQ mode. As each mode

is selected the illuminated pointer on the control

knobs will change colour:

All Blue in ISOLATOR mode

All Red in EQ Mode

Two Blue, one Red (RES control) in FILTER mode

The music channel EQ Section on the XONE:DB4 can operate in one of three different modes. Each

mode is indicated by the colour of the illuminated control knob pointers.

ISOLATOR MODE

In this mode, the EQ provides full attenuation when fully anti-clockwise and a safe +6dB of boost when

fully clockwise. This EQ offers a steep 24dB/octave slope for tight frequency isolation. In isolator mode

the EQ knob pointers are illuminated BLUE.

EQ MODE

In this mode, the EQ provides –26dB of attenuation and +6dB of boost. This EQ has a gentler 12dB/

octave slope better suited to certain styles of music. In EQ mode the knob pointers are illuminated RED.

FILTER MODE

In FILTER MODE, the EQ section becomes a high and low pass filter system with adjustable resonance,

offering precise control over the frequency spectrum. The filters haver a 12dB/octave slope. The HF and

LF knob pointers illuminate BLUE, and the MF RED. The MF pot controls the resonance, or

“sharpness” (Q) of the filter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Allen-Heath Xone DB4 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info