Bedienungsanleitung Allied Telesis AR450S (Seite 63 von 134) (Englisch)

541401

Zoom out

Zoom in

Vorherige Seite

1/134

Nächste Seite

Operating the router 63

Software Release 2.7.1

C613-02021-00 REV F

2. Upload the configuration file.

Upload the configuration file from the router into the TFTP directory of the

TFTP server on the network, using the defaults set above.

UPLOAD FILE=filename.cfg

Monitor the load progress.

SHOW LOAD

When the upload is complete, check that the file is in the TFTP directory on

the network host.

More information

For more information about loading files onto and uploading files from the

router, including using LDAP to load PKI certificate information, see the

Operation chapter in the Software Reference.

Upgrading Router Software

When you first start the router, it automatically loads the software release from

FLASH memory into RAM, where the CPU uses it to run all the router’s

software features. The router may also load a patch file to improve the main

release. The software release and any patch files are current when the router is

produced at the factory.

When Allied Telesyn makes a new patch or release available, you may want to

upgrade the software on your router to use a new patch or release file. You can

download the latest software patches, full software releases, and CLI help files

from the website at: http://www.alliedtelesyn.co.nz/support/ar400

.Release and

patch files are compressed ASCII files, and consist of a header followed by a

sequence of Motorola S-records containing the actual code for the release or

patch. The header has a standard format, which provides information about

the release or patch to the router.

Do not change the header in a release or patch file. At best, this will cause the

file load or install to fail, at worst the router could be put into a state where it

will not boot correctly until field service action is taken.

The current release and patch file are set as the preferred install. The router also

has a very limited version of the software stored in permanent memory

(EPROM). You cannot delete this version as it is the default, or boot install.

When you load a new software release or patch, you can set it to run once, the

next time the router reboots. This temporary install allows you to test run a

new release or patch once, before you make it the preferred install. If the

temporary install fails the router will automatically run the preferred install if

there is one, or otherwise the default install, the next time the router reboots.

When the router reboots, it checks the install information in a strict order:

• Firstly, the router checks the temporary install. If a temporary install is

specified, the router loads it into RAM and runs it. At the same time, it

deletes the temporary install information so it will not load a second

time. This information is deleted even if the temporary install triggers a

fatal condition causing the router to reboot immediately.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Allied Telesis AR450S Seite 63

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info