Bedienungsanleitung Allied Telesis AT-9724TS (Seite 31 von 197) (Englisch)

541393

Zoom out

Zoom in

Vorherige Seite

1/197

Nächste Seite

VLAN Name This allows the entry of a VLAN Name from which a management station will be allowed to manage the Switch

using TCP/IP (in-band via web manager or Telnet).Management stations that are on VLANs other than the one

entered here will not be able to manage the Switch in-band unless their IP addresses are entered in the

Security IP Management menu.If VLANs have not yet been configured for the Switch,the default VLAN contains

all of the Switch's ports.There are no entries in the

Security IP Management table,by default,so any

management station that can connect to the Switch can access the Switch until a management VLAN is

specified or Management Station IP Addressesare assigned.

Click

Apply to let your changes take effect.

Setting the Switch's IP Address using the Console Interface

Each Switch must be assigned its own IP Address,which is used for communication with an SNMP network manager or other TCP/IP

application (for example BOOTP,TFTP).The Switch's default IP address is 10.0.0.1.You can change the default Switch IP address to meet the

specification of your networking address scheme.

The IP address for the Switch must be set before it can be managed with the Web-based manager.The Switch IP address can be automatically

set using BOOTP or DHCP protocols,in which case the actual address assigned to the Switch must be known.The IP address may be set using

the Command Line Interface (CLI) over the console serial port as follows:

Starting at the command line prompt,enter the commands config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy.Where the x's

epresent the IP address to be assigned to the IP interface named System and the y's represent the corresponding subnet mask.

Alternatively,you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z.Where the x's represent the IP address to be assigned

to the IP interface named System and the z represents the corresponding number of subnets in CIDR notation.

The IP interface named System on the Switch can be assigned an IP address and subnet mask which can then be used to connect a management

station to the Switch's Telnet or Web-based management agent.

The system message

Success indicates that the command was executed successfully.The Switch can now be configured and managed via Telnet

and the CLI or via the Web-based management agent using the above IP address to connect to the Switch.

Advanced Settings

The Advanced Settings window contains the main settings for all major functions for the Switch.To view the Advanced Settings window,click its link in

the

Configuration folder.This will enable the following window to be viewed and configured.

Figure 6- 3.Switch Information (Advanced Settings)

Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Allied Telesis AT-9724TS Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info