Bedienungsanleitung Allnet ALL-VPN10 (Seite 36 von 175) (Englisch)

535882

Zoom out

Zoom in

Vorherige Seite

1/175

Nächste Seite

ALL-VPN10 VPN/Firewall WLAN-N WAN Router

Please refer to the explanations in 6.2.3 Configuring Protocol Binding for setting up Protocol Binding and

for examples of collocating router modes with Protocol Binding.

Specify WAN Binding Mode

This mode enables users to assign specific intranet IP addresses, destination application service ports or

destination IP addresses to go through an assigned WAN for external connection. After being assigned, the

specific WAN will only support those assigned Intranet IP addresses, specific destination application service

ports, or specific destination IP addresses. Intranet IP, specific destination application service ports and specific

destination IP that is not configured under the rules will go through other WANs for external connection. For

unassigned WANs, users can select Load Balance mode and select session or IP for load balancing.

● Session Balance: If “By Session” is selected, the WAN bandwidth will automatically allocate

connections based on session number to achieve network load balance.

● IP Balance: If “By IP” is selected, the WAN bandwidth will automatically allocate connections based

on the number of IP addresses to achieve network load balance.

Note!

Only when a device assignment is collocated with Protocol Binding can the balancing function be

brought into full play. For example, an assignment requiring all Intranet IP addresses to go through WAN 1

when connecting with service port 80, or go through WAN 1 when connecting with IP 211.1.1.1, must be

set up in the Protocol Binding Configuration.

Attention: When assigning mode is selected, as in the above example, the IP(s) or service provider(s)

configured in the connection rule will follow the rule for external connections, but those which are not

configured in the rule will still follow the device Load Balance system to go through other WAN ports to

connect with the Internet.

Please refer to the explanations in 6.2.3 Configuring Protocol Binding for setting up Protocol Binding and

for examples of collocating router mode with Protocol Binding.

Strategy Routing Mode

If strategy Routing is selected, the device will automatically allocate external connections based on routing policy

(Division of traffic between Telecom and Netcom is to be used in China) embedded in the device. All you have to do is

to select the WAN (or WAN group) which is connected with Netcom; the device will then automatically dispatch the

traffic for Netcom through that WAN to connect with the Internet and dispatch traffic for Telecom to go through the

WAN connected with Telecom to the Internet accordingly. In this way, the traffic for Netcom and Telecom can be

divided.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Allnet ALL-VPN10 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info