731527
78
Zoom out
Zoom in
Vorherige Seite
1/251
Nächste Seite
7
Operation






Oil level check (par. 5.1.1) - - -
Oil change
1
(par. 6.3) - -
Cleaning the silencer
and the engine (par. 7)
- - -
Checking and cleaning
the air lter
2
(par. 8)
- - -
Changing the air lter (par. 8) - - -
Spark plug check (par. 9) - - -
Changing spark
plugs (par. 9)
- - -
Fuel lter check
3
- - -
1
Change the oil every 25 hours if the engine is
operating under heavy load or in hot weather.
2
Clean the air lter more frequently if the
machine is operating in dusty areas.
3
To be carried out by a Specialised Centre.
6.3 OIL CHANGE
For the required type of oil, observe the
indications provided in the technical data table.
Drain the oil out while the engine
is warm, being careful not to touch
the hot engine nor the drained oil.
Unless otherwise stated in this
machine Instruction Manual, to
change the oil it is necessary to:
1. Place the machine on a at surface.
2. Clean around the ller cap and unscrew
the cap with dipstick (g. 6.A).
3. Provide a suitable container for collecting
the oil and unscrew the drain plug (g. 6.G).
4. Ret the drain plug (g. 6.G) and tighten it.
5. Top up with new oil (par. 5.1.1).
6. Check that the oil level has reached the
«MAX» notch on the dipstick (g. 6.B).
7. Close the cap (g. 6.A) again and clean up
any traces of oil that was possibly spilt.
6.4 CLEANING THE SILENCER
AND THE ENGINE
The silencer must be cleaned
when the engine is cold.
Use a jet of compressed air (g. 7.A) to remove
any debris and dirt that could cause a re
from the silencer and its protective cover.
Ensure that the cooling air intakes
are not obstructed (g. 7.A).
Clean the plastic parts with a sponge
(g. 7.B) soaked in water and detergent.
6.5 AIR FILTER MAINTENANCE
1. Clean around the lter cover (g. 8.A).
2. Take the cover o (g. 8.A) by
unscrewing the two knobs.
3. Remove the ltering element (g. 8.B + 8.C).
4. Take the pre-lter (g. 8.C) out
of the cartridge (g. 8.B).
5. Tap the cartridge (g. 8.B) on a solid
surface and blow it from the inside with
compressed air to remove dust and debris.
6. Wash the pre-lter sponge(g. 8.C) with
water and detergent and leave it to air dry.
IMPORTANT Do not use water,
petrol, detergents or any other
products to clean the cartridge.
IMPORTANT The pre-lter sponge
(g. 8.C) must NOT be oiled.
1. Clean out any dust and debris from inside
the lter housing (g. 8.D) being careful to
close the extraction duct with a cloth (g. 8.E)
to stop them from getting into the engine.
2. Remove the cloth (g. 8.E) , place the ltering
element (g. 8.C + 8.B) in its housing and
put the cover back in place (g. 8.A).
6.6 SPARK PLUG CHECKS
AND MAINTENANCE
1. Take the spark plug down (g. 9.A)
using a socket wrench (g. 9.B).
2. Clean the electrodes (g. 9.C) with a metal
brush, removing any carbonaceous build-up.
3. Using a thickness gauge (g. 9.D)
ensure the gap between electrodes is
correct (0.6 - 0.8 mm).
4. Put the spark plug back in (g. 9.A) and
tighten rmly using a socket wrench (g. 9.B).
Replace the spark plug if the electrodes are
burnt or if the porcelain is broken or damaged.
78

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alpina AT2 72 HA wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info