ENGLISH
- 4 -
Variable suction control
Note:
Once all attachments are in place, unwind a sufficient length of cable and insert the plug into
the wall outlet. A yellow mark on the power cord shows the ideal cable lenghth. Do not pull
the power cord beyond the red mark.
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located the unit to turn the vacuum cleaner “on”.
3. To rewind the power cord, press the cord rewind button with one hand and guide the
power cord with the other hand to ensure that it dose not whip causing damage or injury.
4. To adjust the suction, slide the speed control button on the suction hand to control the
suction power of the vacuum cleaner.
Motor thermostat (Optional)
Important:
This motor is equipped with a motor protective thermostat. If for some reason the vacuum
cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur
unplug the vacuum cleaner from the wall outlet and turn off switch, change dust bag and clean
filters. Allow the unit to cool for approximately 1 hour. To restart, replug into wall outlet and
turn switch back on.
Clean the dust barrel:
1. Press the knob on the dust cup arm
2. Lift dust barrel up
3. Press knob on low end of du st barrel to open the dust barrel cover.
Carry and move away the cleaner:
Note:
This cleaner have a handle at top rear of the body, you can use it to conveniently to carry the
appliance.
Removing & cleaning pre-motor filter and air outlet filter
Warning:
Always unplug the unit from electrical outlet before getting out the dust barrel.
a. Pre-motor filter
1. Press the knob on the dust cup arm
2. Lift dust barrel up
3. Take out the pre-motor filter for cleaning and changing..
b. Centri-Hepa filter
1. Press the knob on the dust cup arm.
2. Lift dust barrel up.
3. Press knob on low end of dust barrel to open the dust barrel cover.
4. Take out the centric Hepa for clean and change.
c. Air outlet filter
1.
Press the air outlet grid knob to open
2. Take out the air outlet filter for clean and change.
Please note: The sponge filter material in the cleaner will became dusty over time. This is
normal and will not affect the performance of the filter. If the sponge filter is so dusty that
suction does not return to 100%, then we suggest that the filter be removed then rinsed
under the faucet and allowed to dry for 24 hours by airing not near the fire or some high
temperature objects before refitting into the vacuum. This should be done once six months or
when suction appears to be reduced obviously.
Important:
Please note that there is a safety switch inside the vacuum to prevent the unit from being run
withhigh vacuum rate. If the vacuum is too high ,the safety switch will be turned on. In this
case, it can minish the vacuum rate and protect the motor from being broken.
