Bedienungsanleitung Alpina T 26 JA (Seite 22 von 27) (Alle Sprachen)

731919

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

e) Adjusting line length when working

(Fig. 10)

This machine is tted with a “Tap & Go” head.

To release more line, tap the cutting line head

against the ground with the engine at top speed:

the line will be released automatically and the

knife will cut o the excess length.

4.2 WHEN WORK IS FINISHED

When you have nished your work:

– Stop the machine as indicated previously (see

3.3).

5. ROUTINE MAINTENANCE

Correct maintenance is essential to maintain

the original eciency and safety of the machine

over time.

WARNING! During maintenance opera-

tions:

– Remove the spark plug cap.

– Wait until the engine is sufficiently cold.

– Never dispose of oils, fuel or other pollut-

ing materials in unauthorised places.

5.1 STORAGE

At the end of each working session, carefully

clean the machine of dust and debris, and make

sure that there are no damaged parts, replacing

any faulty parts. The machine must be stored in

a dry place away from the elements and with the

cover correctly tted.

5.2 CLEANING THE ENGINE

AND THE SILENCER

To reduce re risks, periodically clean the cylin-

der ns with compressed air and clear the silenc-

er area to get rid of sawdust, branches, leaves or

other debris.

5.3 STARTING UNIT

To avoid overheating and damage to the engine,

always keep the cooling air vents clean and free

of sawdust and debris.

If you notice signs of wear on the starter cable,

contact your Dealer for a replacement.

5.4 NUTS AND SCREWS

Periodically check that all the nuts and screws

are securely tightened and the handgrips are

tightly fastened.

5.5 CLEANING THE AIR FILTER (Fig. 11)

IMPORTANT Cleaning the air filter is essential to

guarantee the efficiency and duration of the ma-

chine. Do not work with a damaged filter or with-

out a filter, as this could permanently damage the

engine.

It must be cleaned after every 15 working hours.

Clean the lter as follows:

– Loosen the knob (3), remove the cover (1) and

the lter element (2).

– Wash the lter element (2) with soap and wa-

ter. Do not use petrol or other solvents.

– Leave the lter to dry in the open air.

– Fit the lter element (2) and the cover (1) back

on, tightening the knob (3) again.

5.6 CHECKING THE SPARK PLUG ( (Fig. 12)

Periodically remove and clean the spark plug us-

ing a metal brush to get rid of any deposits.

Check and reset the correct distance between

the electrodes.

Replace the spark plug and fasten it rmly using

the supplied wrench.

The spark plug must be replaced with one with

the same characteristics whenever the elec-

trodes have burnt or the insulation has worn, and

in any case every 100 working hours.

5.7 HEAD LINE REPLACEMENT (Fig. 13)

- Follow the sequence indicated in the gure.

5.8 SHARPENING THE LINE CUTTING

KNIFE (Fig. 14)

– Remove the line cutting knife (1) from the

guard (2) by unscrewing the screws (3).

– Fix the line cutting knife in a vice and sharpen

it using a at le, being careful to retain the

original cutting angle.

– Ret the knife on the guard.

5.9 LONG PERIODS OF DISUSE

IMPORTANT If you are not going to use the ma-

chine for a period of more than 2-3 months, we

recommend you do a few things before putting it

away. This will make it easier when you want to

use the machine again and will also prevent per-

manent damage to the engine.

Before putting the machine away:

– Empty the fuel tank.

– Start the engine and run it idle until it comes to

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alpina T 26 JA Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info